User manual AEG-ELECTROLUX 61370MF-AN

[. . . ] 61370MF-an Glass Ceramic Cooking Surface Operating Instructions Installations Instructions Dear customer, Please read these operating instructions through carefully. Above all, please take note of the «Safety» section on the first few pages. Please keep these operating instructions for later reference. Pass them on to any subsequent owner of the appliance. [. . . ] You can select intermediate settings in the ranges - . = Automatic Heating-Up The cooking zone is set to automatic heating-up. is lit until the automatic feature switches over to the set further coo-king stage. = Residual Heat Indication Danger!The display goes out after the cooking zone cools down. is only displayed when the cooking zone is switched off. You can use the residual heat for melting and keeping food warm. 9 Operating Instructions (GB) Switching on the Casserole Zone Depending on the size of the pan, on the casserole zone the larger ring can be switched on, in addition to the smaller cooking zone, using the touch switch on the glass ceramic cooking surface. Switch on cooking zone in the normal way using the ring switch. Tap the corresponding touch switch on the cooking surface - The larger ring is also switched on. To switch off the larger ring, tap the touch switch again. If the casserole zone is completely switched off using the ring switch, the larger ring must be switched on again, if needed, the next time the zone is switched on. Switching On the Triple Ring Cooking Zone Depending on the size of the pan, on the triple ring zone the two larger rings can be switched on, in addition to the smallest cooking zone, using the appropriate touch switch on the glass ceramic cooking surface. Switch on cooking zone in the normal way using the ring switch. - The smallest ring on the cooking zone is switched on. Tap the corresponding touch switch on the cooking surface once - The larger ring is also switched on. To switch on the largest ring, tap the touch switch again 4. To switch off the larger ring, tap the touch switch again. If the triple ring cooking zone is switched off completely using the ring switch, the larger rings must be switched on again the next time the ring is switched on, if required. . 10 Operating Instructions (GB) Usage, Tips Pans The better the pan, the better the results. · You can recognise good pans by their bases. The base should be thick and as flat as possible. · Pans with aluminium or copper bases can leave metal discoloration on the glass ceramic surface that is very difficult or impossible to remove. · Do not use cast iron pans or pans with damaged bases that are rough or burred. Permanent scratching may occur when the pans are slid. · When cold, pan bases are normally bowed slightly in wards (concave). They should under no circumstances be bowed outwards (convex). Tips on Saving Energy You will save valuable energy if you observe the following tips: · Always place pans on the cooking zone before switching on. [. . . ] · On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place. · Ensure that the seal is correctly seated in the frame and that it is seated against the work surface without leaving any gaps. Additional silicon sea lant must not be applied, this will make removal more difficult in the event of the need for service. 17 Installation Instructions (GB) Installing into a kitchen worksurface Make a note of the serial number on the appliance rating plate prior to installation. This number will be required in the case of requests for service and is no longer accessible after installation, as it is on the original rating plate on the underside of the appliance. maximal 100°C optimal 300 mm minimal 50 mm 18 Installation Instructions R2 60 2 , 5 27 5 21 4, 5 60 = 31 = 0 26 7 22 3 0 53 5 R3 22 3 26 7 = 31 0 = Variant 1; with spring clips Catch spring Screws Worktop Frame Glass ceramic plate min. [. . . ]