User manual AEG-ELECTROLUX 61371M-MN 51J

[. . . ] · Additions or modifications to the appliance are not permitted. · Do not place or store flammable liquids, highly inflammable materials or fusible objects (e. g. plastic film, plastic, aluminium) on or near the appliance. Children's safety · Small children must be kept away from the appliance. [. . . ] This is a characteristic of all ceramic glass cooking zones and does not impair either the function or the life of the appliance. Please follow the instructions from the manufacturer of the combination appliance as well. 3 3 Switching the outside ring on and off 3 By switching the outside rings on or off, the effective heating surface can be matched to the size of the cookware. Before an outside ring can be switched on, the inside ring must be switched on. Triple cooking zone To switch on middle ring To switch on outside ring To switch off outside ring To switch off middle ring Touch Touch Touch Touch Sensor panel for 1-2 seconds. Power indicator One power indicator is lit. First power indicator goes out. Roasting zone To switch on outside ring Sensor panel Touch for 1-2 seconds for 1-2 seconds Power indicator is lit goes out To switch off outside ring Touch 8 Tips on Cooking and Frying Cookware · You can recognise good cookware from the bottoms of the pans. The bottom should be as thick and flat as possible. · Cookware made of enamelled steel or with aluminium or copper bottoms can leave discolorations on the glass ceramic surface which are difficult or impossible to remove. Energy saving 2 2 2 2 Always place cookware on the cooking zone before it is switched on. If possible, always place lids on the pans. Switch cooking zones off before the end of the cooking time, to take advantage of residual heat. Bottom of pans and cooking zones should be the same size. 9 Cleaning and Care 1 1 1 Take care!Sharp objects and abrasive cleaning materials will damage the appliance. Residues from cleaning agents will damage the appliance. Remove residues with water and washing up liquid. Cleaning the appliance after each use 1. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Removing deposits 1. Place a scraper on the glass ceramic surface at an angle. Remove residues by sliding the blade over the surface. [. . . ] The cut surfaces of the worktop are to be protected against moisture using a suitable sealant. The sealant seals the appliance to the work top with no gap. Do not use silicon sealant between the appliance and the work top. [. . . ]