User manual AEG-ELECTROLUX 618K-BN-2

[. . . ] · Repairs to the appliance must only be carried out by trained registered service engineers. 4 Safety during use · Remove stickers and film from the glass ceramic. · There is the risk of burns from the appliance if used carelessly. · Cables from electrical appliances must not touch the hot surface of the appliance or hot cookware. · Overheated fats and oils can ignite quickly. [. . . ] After being switched off, the cooking zones need some time to cool down. Residual heat can be used for melting and keeping food warm. 7 Operating the hob You operate the appliance with the combination appliance's ring switches. The operation and the function of the ring switches is described in the Operating Instructions for the combination appliance. When a cooking zone is switched on, it may hum briefly. This is a characteristic of all ceramic glass cooking zones and does not impair either the function or the life of the appliance. 3 Switching the outside ring on and off 3 By switching the outside rings on or off, the effective heating surface can be matched to the size of the cookware. Before an outside ring can be switched on, the inside ring must be switched on. Triple cooking zone To switch on middle ring To switch on outside ring To switch off outside ring To switch off middle ring Sensor panel Touch Touch Touch Touch for 2 seconds. Power indicator One power indicator is lit. First power indicator goes out. Double ring cooking zone To switch on outside ring To switch off outside ring Sensor field Touch Touch for 2 seconds for 2 seconds is lit goes out Pilot light 8 Tips on Cooking and Frying Cookware · You can recognise good cookware from the bottoms of the pans. The bottom should be as thick and flat as possible. · Cookware made of enamelled steel or with aluminium or copper bottoms can leave discolorations on the glass ceramic surface which are difficult or impossible to remove. Energy saving 2 2 2 2 Always place cookware on the cooking zone before it is switched on. If possible, always place lids on the pans. Switch cooking zones off before the end of the cooking time, to take advantage of residual heat. Considerable danger to the user may result from improper repairs. If the appliance has been wrongly operated, the visit from the customer service technician or dealer may not take place free of charge, even during the warranty period. 11 Installation Instructions Safety instructions The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accordance with the regulations, etc. ) Installation may only be carried out by a qualified electrician. The minimum distances to other appliances are to be observed. Drawers may only be installed with a with protective floor directly under the appliance. The cut surfaces of the work top are to be protected against moisture using a suitable sealant. The sealant seals the appliance to the work top with no gap. Do not use silicon sealant between the appliance and the work top. Avoid installing the appliance next to doors and under windows. Otherwise hot cookware may be knocked off the rings when doors and windows are opened. · Observe electrical safety rules. · Ensure anti-shock protection through correct installation by a qualified electrician. [. . . ] · Moving the panel ring under pressure can scratch the coated metal surfaces. 1 1 1 12 Appliance dimensions Width Depth Height 576 mm 506mm 42mm 13 Assembly 14 15 Removal 16 17 18 Service In the "What to do if . . . " section a number of malfunctions are listed that you can rectify yourself Look there first if a fault occurs. If so, please contact your customer service centre. (You will find addresses and telephone numbers in the section "Customer Service Centres". ) Always prepare in advance for the discussion. This will make diagnosis of the problem easier and also make it easier to decide if a customer service visit is necessary: Please make a note of the following information as accurately as possible: · What form does the fault take? [. . . ]