User manual AEG-ELECTROLUX 63070K-MN 53R

[. . . ] â· Only let bigger children work on the appliance under supervision. â· To avoid small children and pets unintentionally switching the appliance on, we recommend activation of the child safety device. Built-in appliances may only be used after they have built in to suitable built-in units and work surfaces that meet standards. â· In the event of faults with the appliance or damage to the glass ceramic (cracks, scratches or splits), the appliance must be switched off and disconnected from the electrical supply, to prevent the possibility of an electric shock. [. . . ] After being switched off, the cooking zones . Look at the residual heat indicator Residual heat can be used for melting and keeping food warm. The induction cooking zones create the heat required for cooking directly in the base of the cookware. the glass ceramic is merely heated by the residual heat of the cookware. The cooling fan switches itself on and off depending upon the temperature of the electronics. Use the induction cooking zones with suitable cookware. Ring switch To increase To decrease To switch off turn to the right turn to the left turn to zero Fan level to to / Switching the power function on and off The power function makes more power available to the induction cooking zones, e. Ring switch To switch on To switch off Briefly turn to the right past the stop position turn to the left Display The maximum power is reached when the heat setting 9 has been set for all cooking zones. Two cooking zones generate a pair (see figure) and therefore, the power management shares the maximum available power between these cooking zones. When the power function is selected for one cooking zone, the power management makes the additional power for this cooking zone available by reducing the power of the corresponding other cooking zone. The power function is carried out but the heat setting 9 of one of the cooking zones and the power function for the other cooking zone of the pair exceed the maximum power for both at the same time. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Remove Type of dirt sugar, food containing sugar plastics, tin foil limescale and water rings fat splashes shiny metallic discolouration immediately yes yes ------when the appliance has cooled down ----yes yes yes cleaner for glass ceramic or stainless steel* using a scraper* Scratches or dark stains on the glass ceramic that cannot be removed do not however affect the functioning of the appliance. Problem The cooking zones are not functioning Possible cause Remedy The desired heat setting is not Set heat setting set The fuse in the house's electri- Check the fuses. Switching off the child safty device (see section "Child safety device" in the hob user manual) The residual heat indicator is not displaying anything Display is switching between two heat settings lights up The cooking zone was only on If the cooking zone is supfor a short time and is there- posed to be hot, call the Cusfore not hot tomer Service Department. Power management is reducing the power of this cooking zone Unsuitable cookware No cookware on the cooking zone See the section "Switching the power function on and off" Use suitable cookware Place cookware on the cooking zone The diameter of the bottom of Move onto a smaller cooking the cookware is too small for zone the cooking zone Use suitable cookware lights up Cooking zone on for more than two minutes without cookware Automatic switch-off has been triggered and number are displayed Electronics fault Switch off cooking zone, place cookware on cooking zone, switch on cooking zone Switch off the cooking zone. Switch the cooking zone on again Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, is displayed again, call the customer service department If you are unable to remedy the problem by following the above suggestions, please contact your local Service Force Centre. Repairs to the appliance are only to be carried out by qualified service engineers. Considerable danger to the user may result from improper repairs. [. . . ] Do not use silicon sealant between the appliance and the work top. When building in, protect the underside of the appliance from steam and moisture, e. Avoid installing the appliance next to doors and under windows. Otherwise hot cookware may be knocked off the rings when doors and windows are opened. [. . . ]