User manual AEG-ELECTROLUX 65300KF-AN

[. . . ] 65300KF-an Ceramic Glass Cooking Surface Operating Instructions/ Installation Instructions l ll lll III II Dear customer, Please read these operating instructions through carefully. Above all, please take note of the «Safety» section on the first few pages. Please keep these operating instructions for later reference. Pass them on to any subsequent owner of the appliance. [. . . ] Both triple cooking zone indicators illu minate. To switch off the outer zones, press the triple ring zone/casserole zone but ton again, the triple cooking zone must be selected when this is done. If a larger cooking zone is required, the outer zone on the casserole zone can be switched in. Select the casserole zone using the appropriate cooking zone selection but ton and select the desired heat setting ( to ). Press the triple zone/casserole zone button. The casserole zone indicator illuminates. To switch off the outer zone, press the triple zone/casserole zone button again, the casserole zone must be selected when this is done. Switching the triple zone on and off Switching the casserole zone on and off 15 Operating Instructions Setting/changing the cooking time 1. Select the desired cooking zone using the cooking zone selection buttons and set the desired heat setting. Press the "Timer" button to activate the timer function for this cooking zone. or buttons, set or change the amount of time required 3. Using the until the cooking zone is to switch off automatically (e. g. The timer starts after a few seconds and indicates the amount of time left. The small "Timer Active" indicator is also illuminated for the respective coo king zone, e. g. the upper left indicator corresponds to the rear left cooking zone. At the end of the cooking time set, the cooking zone switches off automa tically and an acoustic signal sounds. Touch the TIMER button to switch off the signal and the indicator. For quicker adjustment, leave your finger on the desired value is reached. or button until the . button is operated first, the time setting starts at 99 minutes. If If the the button is operated, the time setting starts at 1 minute. . Displaying the remaining cooking time Select the desired cooking zone using the cooking zone buttons. If the selected cooking zone is in timer mode, the remaining cooking time appears in the "Cooking Time" display field. Use of the timer as an interval timer (egg timer) Important!There must be no cooking zones programmed with the timer! 1. [. . . ] · Built-in ovens and cooking surfaces are fitted with special connector sy stems. They may only be combined with appliances with a matching system. · All cut surfaces are to be sealed with a suitable sealant for protection against moisture. · On tiled work surfaces, the joints in the area where the hob sits on the sur face must be completely filled with grout. [. . . ]