User manual AEG-ELECTROLUX 65301K-MNW45

[. . . ] C65301K Glaskeramik-Kochfeld Glaskeramische kookplaat Table de cuisson vetrocéramique Ceramic glass hob Montage- und Gebrauchsanweisung Montage- en gebruikshandleiding Instructions de montage et mode d'emploi Installation and Operating Instructions Dear Customer, Please read these operating instructions carefully. Above all, please observe the "safety" section on the first few pages. Please retain these operating instructions for future reference. Pass them on to any subsequent owners of the appliance. 1 The warning triangle and/or key words (Warning!, Caution!, Important!) are used to highlight instructions that are important for your safety or for the function of the appliance. [. . . ] If you select a lower setting, the warm up time ends at once. If you start cooking again on a cooking zone that is still warm, the automatic warm up function uses the residual heat. If you again wish to switch on a cooking zone on which hot items are already standing, you should always select the required heat setting with the - sensor field. In this way you can avoid making the food boil over as a result of the extra burst of heat from the automatic warm up. Cooking without the Automatic Warm up Function If you wish to use the cooking zone without automatic warm up, select the required heat setting with the - sensor field. Switch on the appliance and select the desired cooking zone using the cooking zone selection buttons. Touch sensor field - to select the required heat setting from ) to !. 3 You can adjust the heat setting at any time using the + and - buttons, providing the cooking zone has been selected. Select the desired cooking zone using the cooking zone buttons. Press the + and - buttons simultaneously to switch off. 1 When the rings are still hot cooking should be carried out without automatic warm up. 97 Operating Instructions Timer A cooking duration can be set with the integrated timer for all cooking zones. When the end of the cooking duration is reached, the cooking zone switches itself off automatically. Using the cooking zone sensor field, select the required cooking zone and set the required heat setting. Touch the TIMER W sensor field to activate the timer function for this cooking zone. Using the + or - sensor fields set or adjust the required period of time until the zone is to switch off automatically (eg. 15 minutes). After a few seconds the timer will start automatically and will show how much time remains before it will switch off. In addition, the "Timer active" display for the relevant cooking zone will light up, e. g. the top left control indicator corresponds to the rear left cooking zone. At the end of the set cooking time, the cooking zone will switch off automatically and an acoustic signal will sound. Touch the TIMER W sensor field to switch off the signal and control indicator. 98 Operating Instructions 3 To set the timer more quickly, leave your finger on the + or - sensor field until the required time is reached. If the - sensor field is operated first, the time setting will begin at 99 minutes; if the + sensor field is operated first, the time setting will begin at 1 minute. Displaying the remaining cooking time If you select a cooking zone which is in timer mode, the cooking time still remaining appears in the timer display window. Using the timer to measure short periods of time ("egg timer") 3 The timer function can also be used to measure short times without the automatic switch-off function, provided the timer is not already being used for 1 or more cooking zones. No cooking zone may be selected in this case. The cooking zone sensor field with the decimal point in the display must therefore be touched again so that the decimal point goes out. Set the time as described above. Ending the timer function prematurely There are two ways of switching off the timer early: Switching off the cooking zone and timer simultaneously 1. Select the desired cooking zone using the cooking zone buttons. [. . . ] · The hob must be pressed out from below when removed. 109 Installation Instructions Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. The heating element voltage is AC230 V ~. The appliance also works perfectly on older networks with AC220 V ~. [. . . ]