User manual AEG-ELECTROLUX 6530K-MNAC1

[. . . ] 6530 K Piano di cottura da incasso Encimera integrable de cocción Built-In Cooking Surface Istruzioni di montaggio e per l'uso Instrucciones para el montaje y para el uso Installation and Operating Instructions Dear customer, Please read these operating instructions through carefully. Above all please observe the safety instructions on the first few pages of these operating instructions!Please keep these operating instructions for later reference. Pass them on to any subsequent owner of the appliance. 1 Using the warning triangle and/or the key words (Danger!, Caution!, Important!), information that is important for your safety or the correct functioning of the appliance is highlighted. [. . . ] Press the + and - buttons simultaneously to switch off. If you would like to switch on a cook zone again, which already has a hot cooking utensil on it, you should always select the heat setting using the - button. This way you avoid overcooking the food with the automatic fast-boil function. 0 3 Cooking without the automatic warm up function If you want to use the cooking zone in the same way as you are accustomed, that is without the automatic warm up function, then select the desired heat setting with the - button. As soon as steam starts to form or the oil is hot, switch back to the setting necessary for further cooking. 0 1. Switch on the appliance and select the desired cooking zone using the cooking zone selection buttons. The decimal point in the associated display field illuminates. Press the - button, to set the desired cooking setting !The "Heat Setting/Residual Heat" display field for the corresponding cooking zone indicates the current setting. You can adjust the heat setting at any time using the + and - buttons, as long as the cooking zone is selected. Switching off a cooking zone 1. Select the desired cooking zone using the cooking zone buttons. Press the + and - buttons simultaneously to switch off. 0 84 Operation of the cooking surface Locking/unlocking the control panel At any time during the cooking process, the control panel can be locked, with the exception of the "On/Off" button. By this means changes to the settings, e. g. from wiping with a cloth, can be prevented. This function is also useful as a child safety measure. 0 1. Touch the o button until the indicator illuminates. To unlock, touch the lock button again until the indicator extinguishes. If, when the lock button is active, the cooking surface is completely switched off by touching the main button, then when the cooking surface is switched on again, the lock button is active. This means that the lock button must be operated first, before the rings can be switched on again. 85 Operation of the cooking surface Setting/changing the cooking time 0 1. Select the desired cooking zone using the cooking zone selection buttons and set the desired heat setting. Press the "Timer" button to activate the timer function for this cooking zone. Using the + or - buttons, set or change the amount of time required until the cooking zone is to switch off automatically (e. g. The timer starts after a few seconds and indicates the amount of time left. The small "Timer Active" indicator is also illuminated for the respective cooking zone, e. g. the upper left indicator corresponds to the rear left cooking zone. At the end of the cooking time set, the cooking zone switches off automatically and an acoustic signal sounds. [. . . ] · To remove the hob, it must be pressed out from below. 98 Installing and connecting up min. 5 mm 99 Installing and connecting up Electrical connection Assembly and connection of the new appliance may only be performed by an approved installer. Please observe this instruction, otherwise the warranty will not cover any damage that may occur. Only the cable fitted to the cooking surface recess may be used for connecting up the appliance. [. . . ]