User manual AEG-ELECTROLUX 6530K-MNY69

[. . . ] If you require further assistance or advice, please contact our Customer Care Department either by letter or telephone: Customer Care Department AEG Domestic Appliances 55-77 High Street Slough SL1 1DZ Tel: 08705 350350* * calls to this number may be recorded for training purposes 2 23 Table of contents Before you move please contact your nearest Customer Care centre, listed below, to give them details of your new home. They will then ensure that the local service organisation is aware of your move and able to look after you and your appliances. France Senlis Germany Nürnberg Italy Pordenone Sweden Stockholm UK Slough Contents no For the user Page +33 (0) 344 62 29 29 +49 (0) 800 234 7378 +39 (0) 800 117511 +46 (0) 8 672 53 60 Your new appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Safety information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Children should be kept away until the hob has cooled. Installing Do not install the hob if the ceramic glass is damaged or cracked. This hob must be installed according to the instructions supplied. Any installation work must be undertaken by a qualified competent person. Do not alter the specifications or attempt to modify the appliance in any way. Maintenance and Cleaning Only clean this hob in accordance with the instructions given in this book. Service During Use The hob is intended for domestic cooking only. It is not designed for commercial/industrial purposes. Ensure that all the control knobs are in the OFF position when not in use. Do not use the hob if it is damaged in any way, contact your local AEG Service Centre. Never use plastic or aluminium dishes on the hob. Repairs carried out by inexperienced persons may cause injury or serious malfunction of the appliance. Repairs must only be carried out by a qualified/competent person. Contact your local AEG Service Centre. Disposal Make the hob unusable by cutting off the cable. Depress and turn the control knob for the burner to the left to max. The ignition electrode will emit sparks, and when the mixture of gas and air is correct, the burner will be ignited. If it is not possible to connect the unit to mains, a match may be used to ignite the burner. After starting the burner, press the control knob for approx. 10 seconds to activate the automatic thermo-couple (thermo sensor ready). The burner can now be regulated between maximum and minimum Do not install the hob above drawers. 8 17 Maintenance and cleaning It is not necessary to attach the reinforcement beam to the table surface, as it is held in place by a specially designed moulding, which is incorporated in the hob units flanges. Installation in work tops with a base unit underneath If the hob is to be installed on top of a base unit, a board must be mounted underneath the hob (e. g. The board can be mounted as shown in the diagram. This installation method prevents the flames from being extinguished if you close the door of the base unit hard. If the back panel of the cupboard unit is of thin 4 mm material, it will need to be reinforced. This procedure will prevent the gas being blown out if the cupboard door is slammed shut. For reasons of hygiene and safety, the cooking zones must be kept clean. [. . . ] Tough stains can be removed by rubbing the stain hard with kitchen towel. Wipe off remaining cleaning agent with a damp cloth. Make sure that the ceramic glass is dry when you heat it up again. Ceramic glass can develop rainbow-like stripes if heated while damp. [. . . ]