User manual AEG-ELECTROLUX 6561GM

[. . . ] Use this section until you are familiar with your new Hob. The section "Cleaning and Maintenance" provides information on both daily and more thorough cleaning of the individual components of the Hob. Should problems arise when you use the Hob, you can look in the section "Before calling service", where there are instructions on how to remedy some practical and technical problems yourself. Regards, 2 Table of contents Contents For the user Your new appliance . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Please note: It is very important that the inner burner ring/outer burner ring is placed correctly, together with the cover. If the burner cover/rings are incorrectly fitted the burner will not operate correctly, and the burner may be damaged within a short space of time. It is also important, that the inner air ring is placed correctly. Cover Burner ring Ignition electrode (A) The burner has been provided with an ignition electrode. As long as the operating knob is depressed, the automatic ignition will ensure that a spark is emitted between the ignition electrode and the burner cover. Ignition electrode (A) Thermo couple (B) Inner burner Thermo couple (B) The gas unit features fully-secured gas taps (thermo-couple) In case the flame goes out, the thermo couple automatically prevents gas admission after a few seconds (Max. Note: Gas will flow while the operation button is pressed - See start-up procedure. Outer burner 8 Ignition 1. Depress and turn the control knob for the burner to the left to max. The ignition electrode will emit sparks, and when the mixture of gas and air is correct, the burner will be ignited. If it is not possible to connect the unit to mains, a match may be used to ignite the burner. After starting the burner, press the control knob for approx. 10 seconds to activate the automatic thermo-couple (thermo sensor ready). The burner can now be regulated between maximum and minimum 9 Maintenance and cleaning For reasons of hygiene and safety, the cooking zones must be kept clean. Grease stains and spilled food generate smoke when heated, and can even cause fire. Splashguard The splashguard can be removed to make it easier to clean the surface. Hold the splashguard as shown in the diagram. Clean the top surface as described in "cleaning the steel surface". Be aware of the two retaining pegs, which are sharp. Replace the splashguard in position ENSURE that it is fitted the correct way round. Never use hard or sharp implements to lift off the splashguard. Do not wash the splashguard in a dishwasher. The hob must not be used with the splashguard off. 10 Stainless steel surfaces Perform daily cleaning with a slightly damp cloth. For more severe soiling, use a liquid cream. Always clean the steel in the direction of the steel finish. [. . . ] The kit, product number 949 600 970, can be ordered from your kitchen appliance dealer. 3 mm (the main switch may be used) Wiring HO5V2V2-F Blue and brown: 51 mm +/- 3 mm Yellow/Green: 61 mm +/- 3 mm 19 Service If the hob is not working correctly, please carry out the following checks before contacting your local AEG Service Centre. IMPORTANT: If you call out an engineer to a fault caused by incorrect use or installation, a charge will be made even if the hob is under guarantee. Sympton: There is no spark when lighting the gas Solution Check hob is connected to the electricity supply. [. . . ]