User manual AEG-ELECTROLUX 66300K-IN

[. . . ] 66300 K-IN Ceramic glass hob Table de cuisson vitrocéramique Glaskeramische kookplaat Installation and Operating Instructions Instructions de montage et mode d'emploi Montage- en gebruiksaanwijzing Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Information concerning your personal safety. [. . . ] Using the - timer setting sensor panel, set the timer to 00: ­ only the timer will switch itself off. ­ the cooking zone will remain in operation. Countdown timer To be able to use the countdown timer the appliance must be switched on, but all the cooking zones must be switched off. Set the desired period of time using the + or - timer setting sensor panels. The countdown timer function will be activated after several minutes and the remaining time will be displayed. To reset the remaining time, touch the timer sensor panel and change the setting using the + or - sensor panels for setting the timer. After the set period of time has elapsed an acoustic signal sounds and the timer display flashes 00. To switch off the signal, touch the timer sensor panel. 21 Blocking/unblocking the control panel At any stage of the cooking process the control panel, with the exception of the "On/Off" sensor panel, can be blocked in order to prevent the settings being changed e. g. Touch the "block" sensor panel for approx. one second. 3 The control light for the "block" sensor panel will illuminate. To unblock the panel, touch the "block" sensor panel again for approx. The control light in the "block" sensor panel will go out. When you switch the appliance off the blocking function is automatically switched off. 22 Uses, Tables and Tips Pans · You can recognise good pans by their bases. The base should be as thick and flat as possible. · Pay particular attention when buying new pans to the diameter of the base. Manufacturers often give only the diameter of the upper rim. · Pots with aluminium or copper bases can cause metallic discolouring on the ceramic glass surface, which is very difficult or impossible to remove. · Do not use cast iron pans or pans with a rough, burred or damaged base. This can produce permanent scratching if the pan is slid across the surface. · When cold, pan bases are normally bowed slightly inwards (concave). They should never be bowed outwards (convex). · If you wish to use special types of pan (e. g. a pressure cooker, simmering pan, wok, etc. ), please observe the manufacturer's instructions. 2 Energy saving tips · Always position pots and pans before switching on the cooking zone. [. . . ] The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cutout, earth leakage tripsorfuse. A type H05VV-F cable or one with a higher grade must be used as the mains connecting cable. The connection must be carried out as shown in the diagram. [. . . ]