User manual AEG-ELECTROLUX 66300KF-AN

[. . . ] 66300KF-an Ceramic Glass Cooking Surface Operating and Installation Instructions Dear customer, Please read these operating instructions carefully. Pay particular attention to the section Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. [. . . ] three seconds. An acoustic signal will sound as confirmation. Touch any heat setting sensor field . will appear in the displays, and the child safety lock is activated. The appliance will switch itself off automatically after a few seconds. 19 Overriding the child safety lock The child safety lock can be overridden in order to use the appliance (until the appliance is switched off again). When the appliance is switched on again the child safety device is activated once again. Switch on the appliance. When the child safety device has been activated, 2. Touch any two heat setting sensor fields and will be displayed. simultaneously. An acoustic signal will sound as confirmation. The child safety device has been overridden until the appliance is switched off, and the cooking sur- face can be used as normal. 20 Switching off the child safety lock 1. Switch on the appliance. When the child safety device has been activated, 2. Touch the will be displayed. sensor field for approx. three seconds. An acoustic signal will sound as confirmation. Touch any heat setting sensor field . The displays will become dark, and the child safety device is switched off. The appliance will switch itself off automatically after a few seconds. 21 Timer There are two ways to use the timer: - as a safety cut-out function. Set a cooking period for a cooking zone, and after this time has elapsed the cooking zone will automatically switch itself off. This function can be used for more than one cooking zone simultaneously. - as a countdown timer without a cut-out function ("egg timer"), whereby an acoustic signal can be heard after the set period of time has elapsed. The countdown timer cannot be used if a cooking zone is switched on. Safety cut-out The cooking zone(s) for which you want to use the safety cut-out function must be switched on. Using the timer sensor panel, select the cooking zone for which the safety cut-out is to be set. By touching the timer sensor panel once the first active cooking zone is selected in a clockwise direction, and the corresponding control lamp will flash rapidly. Hereby the (e. g. ) left rear control lamp corresponds to the left will appear in the timer display. The next active cooking zone is selected by touching the timer sensor panel again. 22 2. While the control lamp is flashing rapidly, use the or timersetting sensor panels to set the desired period of time for this cooking zone up un- til the point where it automatically switches itself off (e. g. 15 minutes). The safety cut-out function will be activated after several minutes. [. . . ] · On tiled work surfaces, the joints in the area where the hob sits on the sur- face must be completely filled with grout. · On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place. · Ensure that the seal is correctly seated in the frame and that it is seated against the work surface without leaving any gaps. Additional silicon sea- lant must not be applied, this will make removal more difficult in the event of the need for service. 34 Installing into a kitchen worksurface Make a note of the serial number on the appliance rating plate prior to installation. [. . . ]