User manual AEG-ELECTROLUX 66300KF-AN 98F

[. . . ] 66300KF-an Glaskeramik-Kochfeld Ceramic glass hob Table de cuisson vitrocramique Montage- und Gebrauchsanweisung Installation and Operating Instructions Instructions de montage et mode d'emploi Dear Customer, Please read these user instructions carefully and keep them to refer to later. Please pass the user instructions on to any future owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning!Information that affects your personal safety. Information that prevents damage to the appliance. [. . . ] Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Removing deposits 1. Place a scraper on the glass ceramic surface at an angle. Remove residues by sliding the blade over the surface. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Remove Type of dirt sugar, food containing sugar plastics, tin foil limescale and water rings fat splashes shiny metallic discolorations imme- when the appliance has diately cooled down yes yes ----------yes yes yes using a scraper* cleaner for glass ceramic or stainless steel* *Scrapers and cleaners for glass ceramic and stainless steel can be purchased in specialist shops 3 3 Remove stubborn residues with a cleaner for glass ceramic or stainless steel. Scratches or dark stains on the glass ceramic that cannot be removed do not however affect the functioning of the appliance. 43 Metal dcor strips 1 Warning!Do not use vinegar, lemon juice or lime slaking agents on the cooking surface's dcor strips, otherwise dull spots will result. When cleaning do not introduce flat objects (e. g. knives) under the dcor strips, as otherwise these can possibly become detached. Wipe metal dcor strips with a damp cloth and a little washing up liquid. Soak dried on spillages with a wet cloth. Afterwards wipe off and rub dry. 44 What to do if . . . Problem The cooking zones will not switch on or are not functioning Possible cause Remedy More than 10 seconds have Switch the appliance on passed since the appliance again. was switched on The child safety device is switched on l Several sensor fields were touched at the same time Safety cut-out has been triggered Deactivate the child safety device (See the section "Child safety device") Only touch one sensor field Remove any objects (pan, cloths, etc. ) that are lying on the control panel. Switch the appliance on again Switch off the lock (See the section "Locking/unlocking the control panel") The lock is switched on l Acoustic signal sounds The control panel is wholly Remove objects. when appliance is switched or partly covered by oboff jects. The residual heat indicator The cooking zone was only If the cooking zone is supis not displaying anything on for a short time and is posed to be hot, call the therefore not hot Customer Service Department. The automatic warm up function is not switching itself on There is still residual heat on the cooking zone h The highest heat setting is set Let the cooking zone cool down The highest heat setting has the same power as the automatic warm up function 1. Set the cooking zone using the sensor field The heat setting was set using the sensor field Acoustic signal sounds and The On/Off sensor field has Do not place any objects appliance switches itself on been covered up, e. g. by a on the control panel and then off again; after 5 cloth seconds another acoustic signal sounds 45 Problem _ is lit Possible cause Remedy Overheating protection for Switch off the cooking the cooking zone has been zone. Switch the cooking triggered zone on again Electronics fault Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, e is displayed again, call the customer service department e and number are displayed e and minus are displayed Light rays that are too Briefly shade the control strong on the control pan- panel, for example with el, for example bright sun- the hand Acoustic signal light sounds, appliance switches itself off Switch appliance on (again) 1 3 If you are unable to remedy the problem by following the above suggestions, please contact your dealer or the Customer Care Department. Repairs to the appliance are only to be carried out by qualified service engineers. [. . . ] Domaniewska 41 02-034 Warszawa tel. : 022 874 33 33 fax: 022 874 33 00 Russia Electrolux Russia Ltd. 16 Olympiysky prospekt 129090 Moscow Tel. : (095) 937 7837 Fax: (095) 926 5513 Bulgaria Electrolux Bulgaria E. O. O. D. 2 980 5276 Cyprus Hadjikyrlakos & Sons Ltd. Box 21587 Nicosia 1511 Service Telephones: Nicosia 02 481226 Limassol 05 562182 Larnaca 04 633929 Paphos 06 932 699 Estonia Electrolux Estonia Ltd. [. . . ]