User manual AEG-ELECTROLUX 66301K-MN

[. . . ] 66301K-mn Ceramic glass hob Table de cuisson vetrocramique Glaskeramische kookplaat Installation and Operating Instructions Instructions de montage et mode d'emploi Montage- en gebruikshandleiding Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Information concerning your personal safety. [. . . ] Switch on the appliance. When the child safety device has been activated, l will be displayed. three seconds. An acoustic signal will sound as confirmation. Touch any heat setting sensor field . The displays will become dark, and the child safety device is switched off. The appliance will switch itself off automatically after a few seconds. 21 Timer There are two ways to use the timer: as a safety cut-out function. Set a cooking period for a cooking zone, and after this time has elapsed the cooking zone will automatically switch itself off. This function can be used for more than one cooking zone simultaneously. as a countdown timer without a cut-out function ("egg timer"), whereby an acoustic signal can be heard after the set period of time has elapsed. The countdown timer cannot be used if a cooking zone is switched on. 3 Safety cut-out The cooking zone(s) for which you want to use the safety cut-out function must be switched on. Using the timer sensor panel, select the cooking zone for which the safety cut-out is to be set. By touching the timer sensor panel once the first active cooking zone is selected in a clockwise direction, and the corresponding control lamp will flash rapidly. Hereby the (e. g. ) left rear control lamp corresponds to the left rear cooking zone. The next active cooking zone is selected by touching the timer sensor panel again. 22 2. While the control lamp is flashing rapidly, use the or timersetting sensor panels to set the desired period of time for this cooking zone up until the point where it automatically switches itself off (e. g. 15 minutes). The safety cut-out function will be activated after several minutes The control lamp will now flash more slowly and the remaining cooking time will be shown in the display as it elapses. If the safety cut-out function has been set for more than one cooking zone, the time displayed will be that for the cooking zone with the shortest period of cooking time remaining. The control lamps for the other cooking zones for which the safety cut-out function has been set will illuminate. To display the remaining cooking time for any of these cooking zones, it must be selected using the timer sensor panel, and the corresponding control lamp will then flash rapidly. To reset the remaining cooking time the desired cooking zone must be selected using the timer sensor panel. The corresponding control lamp will then flash more rapidly. The settings are reset using the or timer setting sensor panels. After the set period of cooking time has elapsed the cooking zone automatically switches itself off, an acoustic signal sounds for two minutes and the timer display flashes 00. To switch off the signal, touch the timer sensor panel. To make the setting more quickly, touch any of the or timer setting sensor panels until the desired value is reached. [. . . ] The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cutout, earth leakage tripsorfuse. A type H05VV-F cable or one with a higher grade must be used as the mains connecting cable. The connection must be carried out as shown in the diagram. [. . . ]