User manual AEG-ELECTROLUX 6630K-MN

[. . . ] 6630 K-MN Ceramic glass hob Table de cuisson vetrocramique Glaskeramische kookplaat Installation and Operating Instructions Instructions de montage et mode d'emploi Montage- en gebruikshandleiding Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Information concerning your personal safety. [. . . ] The next active cooking zone is selected by touching the timer sensor panel again. 21 2. While the control lamp is flashing rapidly, use the or timersetting sensor panels to set the desired period of time for this cooking zone up until the point where it automatically switches itself off (e. g. 15 minutes). The safety cut-out function will be activated after several minutes The control lamp will now flash more slowly and the remaining cooking time will be shown in the display as it elapses. If the safety cut-out function has been set for more than one cooking zone, the time displayed will be that for the cooking zone with the shortest period of cooking time remaining. The control lamps for the other cooking zones for which the safety cut-out function has been set will illuminate. To display the remaining cooking time for any of these cooking zones, it must be selected using the timer sensor panel, and the corresponding control lamp will then flash rapidly. To reset the remaining cooking time the desired cooking zone must be selected using the timer sensor panel. The corresponding control lamp will then flash more rapidly. The settings are reset using the or timer setting sensor panels. After the set period of cooking time has elapsed the cooking zone automatically switches itself off, an acoustic signal sounds for two minutes and the timer display flashes 00. To switch off the signal, touch the timer sensor panel. To make the setting more quickly, touch any of the or timer setting sensor panels until the desired value is reached. If the timer setting sensor panel is actuated first, the time setting will begin at 99 minutes, and if the timer setting sensor panel is actuated first, the time setting will begin at 1 minute. 3 22 Switching off the safety cut-out function before it has come to an end There are two ways to switch off the safety cut-out function before it has come to an end. Switch off the cooking zone and timer simultaneously 1. Using the cooking setting selector sensor panel, reset the desired cooking zone to zero: the cooking zone and timer will switch themselves off. Switch off the timer the cooking zone remains active 1. Select the desired cooking zone using the timer sensor panel. The corresponding control lamp will then flash more rapidly. Using the timer setting sensor panel, set the timer to 00: only the timer will switch itself off. the cooking zone will remain in operation. Countdown timer To be able to use the countdown timer the appliance must be switched on, but all the cooking zones must be switched off. Set the desired period of time using the or timer setting sensor panels. The countdown timer function will be activated after several minutes and the remaining time will be displayed. [. . . ] The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cutout, earth leakage tripsorfuse. A type H05VV-F cable or one with a higher grade must be used as the mains connecting cable. The connection must be carried out as shown in the diagram. [. . . ]