User manual AEG-ELECTROLUX 6630K-MN 94F

[. . . ] Important: Information on how to avoid damaging the appliance. Information and practical tips Environmental information 1. These numbers indicate step by step how to use the appliance. These operating instructions contain information on steps you can take yourself to rectify a possible malfunction. [. . . ] When the appliance is switched on again the child safety device is activated once again. Switch on the appliance. When the child safety device has been activated, l will be displayed. Touch any two heat setting sensor fields and simultaneously. An acoustic signal will sound as confirmation. The child safety device has been overridden until the appliance is switched off, and the cooking surface can be used as normal. 19 Switching off the child safety lock 1. Switch on the appliance. When the child safety device has been activated, l will be displayed. three seconds. An acoustic signal will sound as confirmation. Touch any heat setting sensor field . The displays will become dark, and the child safety device is switched off. The appliance will switch itself off automatically after a few seconds. 20 Timer There are two ways to use the timer: as a safety cut-out function. Set a cooking period for a cooking zone, and after this time has elapsed the cooking zone will automatically switch itself off. This function can be used for more than one cooking zone simultaneously. as a countdown timer without a cut-out function ("egg timer"), whereby an acoustic signal can be heard after the set period of time has elapsed. the cooking zone will remain in operation. Countdown timer To be able to use the countdown timer the appliance must be switched on, but all the cooking zones must be switched off. Set the desired period of time using the or timer setting sensor panels. The countdown timer function will be activated after several minutes and the remaining time will be displayed. To reset the remaining time, touch the timer sensor panel and change the setting using the or sensor panels for setting the timer. After the set period of time has elapsed an acoustic signal sounds and the timer display flashes 00. To switch off the signal, touch the timer sensor panel. 23 Blocking/unblocking the control panel At any stage of the cooking process the control panel, with the exception of the "On/Off" sensor panel, can be blocked in order to prevent the settings being changed e. g. Touch the "block" sensor panel for approx. one second. 3 The control light for the "block" sensor panel will illuminate. To unblock the panel, touch the "block" sensor panel again for approx. The control light in the "block" sensor panel will go out. When you switch the appliance off the blocking function is automatically switched off. 24 Uses, Tables and Tips Pans The better the pan, the better the results. [. . . ] Additional silicon sealant must not be applied; this would make removal more difficult when servicing. The hob must be pressed out from below when removed. 34 Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. The appliance also works perfectly on older networks with AC220V~. [. . . ]