User manual AEG-ELECTROLUX 6630K-MN 54S

[. . . ] Important: Information on how to avoid damaging the appliance. Information and practical tips Environmental information 1. These numbers indicate step by step how to use the appliance. These operating instructions contain information on steps you can take yourself to rectify a possible malfunction. [. . . ] The control lamps for the other cooking zones for which the safety cut-out function has been set will illuminate. To display the remaining cooking time for any of these cooking zones, it must be selected using the timer sensor panel, and the corresponding control lamp will then flash rapidly. To reset the remaining cooking time the desired cooking zone must be selected using the timer sensor panel. The corresponding control lamp will then flash more rapidly. The settings are reset using the + or timer setting sensor panels. After the set period of cooking time has elapsed the cooking zone automatically switches itself off, an acoustic signal sounds for two minutes and the timer display flashes 00. To switch off the signal, touch the timer sensor panel. To make the setting more quickly, touch any of the + or - timer setting sensor panels until the desired value is reached. If the - timer setting sensor panel is actuated first, the time setting will begin at 99 minutes, and if the + timer setting sensor panel is actuated first, the time setting will begin at 1 minute. 3 20 Switching off the safety cut-out function before it has come to an end There are two ways to switch off the safety cut-out function before it has come to an end. Switch off the cooking zone and timer simultaneously 1. Using the heat setting selector sensor panel, reset the desired cooking zone to zero: the cooking zone and timer will switch themselves off. They should never be bowed outwards (convex). If you wish to use special types of pan (e. g. a pressure cooker, simmering pan, wok, etc. ), please observe the manufacturer's instructions. 2 Energy saving tips Always position pots and pans before switching on the cooking zone. Whenever possible always position the lids firmly on pots and pans to cover completely. Switch off the cooking zones before the end of the cooking time to use the residual heat such as to keep foods warm or for melting. The base of the pan should be the same size as the cooking zone. 23 Advice on Cooking with and without Automatic Warm up The automatic warm up function is suitable for: dishes that start off cold, are heated up at high power and do not need to be continually watched when cooking on the selected heat setting, dishes that are put in a hot frying pan. The automatic warm up function is not suitable for: goulash, beef olives and similar braised dishes that need continual turning until browned correctly, have liquid added and are then braised until cooked, dumplings, pasta dishes with large amounts of liquid, cooking with pressure cookers, very large quantities of soup/stew with more than 2 litres of liquid. General notes: When cooking without the automatic warm up function, we recommend the use of a high heat setting to warm up the food (using the button) and then leave the dish to finish cooking at an appropriate lower heat setting. Take special note of the results when you first use the appliance!You can then decide which heat setting is the best for "your dishes" in the "quantities you are accustomed to preparing" with "your pans". You will then quickly appreciate the advantages of the automatic function and will feel relaxed about using your new hob. 24 Settings for Cooking on the Zones The figures in the following table are benchmark figures. [. . . ] The two ends of the tape should join in the middle of one side. After trimming the tape (allow it to overlap by 2-3 mm), press the two ends together. 31 Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. The appliance also works perfectly on older networks with AC220V~. [. . . ]