User manual AEG-ELECTROLUX 68000KF-BNUK

[. . . ] 68000KF-BN Ceramic glass induction hob Installation and Operating Instructions Dear Customer, Please read these operating instructions carefully. Above all, please observe the "safety" section on the first few pages. Please retain these operating instructions for later reference. Pass them on to any subsequent owners of the appliance. 1 3 2 The following symbols are used in the text: Safety Instructions Warning: Information concerning your personal safety. [. . . ] With the + or - sensor fields select heat setting 9. Stop briefly and touch the + sensor field again. 21 a lights up in the heat setting display. 3. Next, touch the sensor field - and set the required continued heat setting 1 to 8. The heat setting selected for further cooking then is displayed. 3 After 5 seconds, a appears in the display again instead of heat setting selected for further cooking. The heat setting is displayed again after the heating-up time has ended. If you select a higher heat setting when the automatic function is in operation, e. g. from 3 to 5, the previous heating-up time is taken into account. If you select a lower setting, then the automatic function is brought to an immediate end. If you start cooking again on a cooking zone that is still warm, the automatic heating-up function uses the residual heat. This saves time and energy. 22 Cooking without the Automatic Heating-Up Function 1. For heating up/browning, select a high power. As soon as steam forms or the fat is hot, switch back to the required heat setting for the remainder of the cooking time. Note: When cooking with the induction cooking zone you should take into account that ­ the heating-up times are reduced by the direct energy transfer to the pan!­ the cooking process stops immediately after the cooking zone is switched off (no boiling over!) 2 Residual Heat Indicator When an individual cooking zone or the entire hob is switched off, any residual heat is shown with an h (for "Hot") in the digital display for the appropriate cooking zones. Even after the cooking zone has been switched off, the residual heat indicator only goes out when the cooking zone is cold. You can use the residual heat for melting and keeping food warm. As long as the residual heat indicator is illuminated, there is a risk of burns. If the power supply is interrupted the h symbol will also go out and information about residual heat will no longer be available. However, it is still possible to burn yourself. This can be avoided by taking care around the hob. 2 1 1 23 Locking/Unlocking the Control Panel With the exception of the "On/Off" sensor field the control panel can be locked at any required time during cooking in order to prevent adjusting the settings such as when wiping over with a cloth. This function is also suitable as a child safety feature. Touch the "Lock" sensor field until the control indicator comes on. 3 2. [. . . ] Stick these on underneath the cooking surface along the outer edge of the ceramic glass hob top. The ends of the sealing tapes must overlap. 37 Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. The appliance also works perfectly on older networks with AC220V~. [. . . ]