User manual AEG-ELECTROLUX 68031K-MN

[. . . ] Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. [. . . ] Switching off the child safety device (Do not set a heat setting. The child safety device can only be switched on and off, if no heat setting is set. The child safety device can be switched off in this way for a single cooking session; it remains activated afterwards. Touch Control panel Switch appliance on for 4 seconds lights up Display/Signal Until the appliance is next switched off, it can used as normal. After switching off the appliance, the child safety device is active again. After overriding the child safety device, a heat setting or a function must be set within approx. 10 seconds, otherwise the appliance automatically switches itself off. Switching the power function on and off The power function makes more power available to the induction cooking zones, e. After that the induction cooking zone automatically switches back to heat setting 14. To switch on To switch off Control panel Touch Touch a heat setting Display If the power function has ended, the cooking zones automatically switch back to the heat setting set previously. power Management The cooking zones of the cooking surface have a maximum power. The maximum power is reached when the heat setting 14 has been set for all cooking zones. Two cooking zones generate a pair (see figure) and therefore, the power management shares the maximum available power between these cooking zones. When the power function is selected for one cooking zone, the power management makes the additional power for this cooking zone available by reducing the power of the other cooking zone. The power function is carried out but the heat setting 14 of one of the cooking zones and the power function for the other cooking zone of the pair exceed the maximum power for both at the same time. For this purpose, the power management reduces the power of the cooking zone that switched on first from 14 to example 5 and the display of this cooking zone changes between 14 and 5 and then stays at the current possible maximum 5. (If the display changes between 14 and 5 or 14 and 3 or another value depends on the type of appliance and the size of the cooking zone. Function Automatic cut-out Condition a heat setting is set Outcome after the time has elapsed acoustic signal 00 flashes Cooking zone switches off acoustic signal 00 flashes Cooking zones not in use If just one countdown value is set you can change it only when the appliance is switched on. If a heat setting is set on this cooking zone in addition to a countdown timer, the cooking zone is switched off after the time set has elapsed. Control panel Touch once Display Pilot light of the first cooking zone flashes Pilot light of the second cooking zone flashes Pilot light of the third cooking zone flashes Pilot light of the fourth cooking zone flashes If other timer functions are set, after a few seconds the shortest remaining time of all the timer functions is displayed and the corresponding pilot light flashes. After a few seconds the pilot light flashes more slowly. Control panel Select cooking zone Indicator Pilot light of cooking zone selected flashes faster Time remaining is displayed The time remaining counts backwards to 00. [. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. The laws, ordinances, directives and standards in force in the country of use are to be followed (safety regulations, proper recycling in accordance with the regulations, etc. [. . . ]