User manual AEG-ELECTROLUX 7010TITAN

[. . . ] Snap the hose into the vacuum cleaner as shown in the picture. When removing the hose, press the catch at the coupling and withdraw. B Attach the extension tubes to the hose handle and the floor nozzle. When disconnecting, twist slightly and pull apart. [. . . ] The bag should therefore be changed even if it is not full. When changing a dust bag: open the lid of the bag compartment. M Pull the bag closer closed, grasp the cardboard disc and lift out the full bag. The dust bag can be thrown away with everyday rubbish. The bag compartment can be cleaned with a soft cloth. N Put in the new dust bag by slotting the cardboard disc into the holder. The lid cannot be closed over an unfitted bag. When vacuuming finely ground dust, flour etc. , the pores of the dust bag are quickly blocked, especially if you start with an empty bag. This can be prevented by first vacuuming in a fist-sized piece of cotton wool. O The safety filter in the bag compartment should be changed at about every 5th dust bag. Open the cover, lift out the dust bag and remove the filter. P The HEPA filter should be cleaned when the indicator lamp light is on or at every 5th dust bag. Press the release button to open the filter hatch and remove filter unit. Q Rinse the inside (dirty side) of the filter unit under warm tap water only. Do not use cleaning agents and avoid touching the delicate filter surface. Tap the filter frame to remove excess water. Repeat cleaning procedure four times and allow the filter to air dry. The original filtering performance is now restored. Replace the unit back into the cleaner and close cover ensuring it is properly fastened. R When storing the vacuum cleaner, it is to be switched off and the cable disconnected from the mains. The vacuum cleaner is to be stored in a dry place at room temperature. The hose and tube can be attached as shown in the picture. The vacuum cleaner is for domestic use only and has been designed to ensure maximum safety and performance. [. . . ] when vacuumcleaning carpets or other soft materials. When the nozzle is lifted, the valve is reset. If the safety valve triggers repeatedly during normal use, check and remedy any blockage in the hose, tubes, nozzle or filters. Before you carry out any maintenance operation, unplug the appliance so that it is solated from the power source. AUTHORISED SERVICE CENTRES New South Wales Sydney: Godfreys, 169 Paramatta Road, Auburn, NSW 2144. [. . . ]