User manual AEG-ELECTROLUX 710D-D/CH

[. . . ] 4 First use . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Set the water softener . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6 Use of dishwasher salt . . . . . . . . . . . . . . . . . . . . . . . . . . . . 7 Use of rinse aid . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] They can also contain other different agents depending on which kind of tablets you choose ("3 in 1", "4 in 1", "5 in 1" etc. . . ). Check whether these detergents are suitable for your water hardness. Once this function is selected it will remain active for all following wash programmes. With the selection of this function the inflow of rinse aid and salt from each respective supply container is automatically deactivated and also the indicator lights for salt and rinse aid are deactivated. When using the "Multitab function", the cycle durations may change. If this is the case, the running time for the programme is automatically updated on the digital display. 14 electrolux Activate/deactivate the ''Multitab function'' before the start of a washing programme. Once the programme is running, the "Multitab function " can NO longer be changed. If you want to cancel the "Multitab function " you have to cancel the programme setting and then deactivate the ''Multitab function''. In this case you have to set a washing programme (and desired options) again. Activation/deactivation of the Multitab function To activate the Multitab function, press the Multitab button. To deactivate the function press the Multitab button again. Close the dishwasher door, the programme starts automatically. The phase indicator lights will go off, except for the phase under way. The digital display shows the running time of the programme. electrolux 15 The indicator light of the programme selection button remains on with a fixed light. Setting and starting the programme with delay start 1. Once selected the washing programme and options, press the delay start button until the number of hours for the delay start appear in the digital display. The start of the selected washing programme can be delayed for between 1 and 19 hours. Close the dishwasher door, the countdown starts automatically. The countdown will decrease with steps of 1 hour. The opening of the door will interrupt the countdown. Close the door; the countdown will continue from the point at which it was interrupted. Once the delay start has elapsed the programme will start automatically. [. . . ] The waste connection must be at a height of between 30 cm (minimum) and 100 cm (maximum) from the bottom of the dishwasher. ameter must be no smaller than the diameter of the hose provided. Likewise the internal diameter of the couplings used for connections to the waste outlet must be no smaller than the diameter of the hose provided. When connecting the drain hose to an under sink trap spigot, the entire plastic membrane (A) must be removed. Failure to remove all the membrane will result in food particles building up over time eventually blocking the dishwasher drain hose spigot The drain hose can face either to the right or left of the dishwasher Ensure the drain hose is not bent or squashed as this could prevent or slow down the discharge of water. [. . . ]