User manual AEG-ELECTROLUX 7130M-DN

[. . . ] Do not allow this machine to be used as a toy. Close attention is necessary when the sewing machine is used by or near children. â· Use this sewing machine only for its intended use as described in this manual. Use only aceessories recommended by the manufacturer as contained in this manual. [. . . ] Turning forward the balance wheel and move thread take-up lever to the highest positon. Raise presser foot and insert the spool into spoolholder as shown in the illustration. Draw thread from the back side of the spool. (1) Wind thread past thread retainer by both hands. (2) Hold the thread and pull it into the thread tension disc and then past the thread plate. (3) Pull up the thread tightly and let it through the slit of thread take-up lever from the right side. (4) Then pull down thread and let it through the thread hook. (5) Pull down thread and let it go through the catch the thread hook. (6) Pull thread through needle hole from the front to the back. Instruction: Cut the thread with sharp scissors so as to make easy threading. Draw up lower thread (1) Lift presser foot and hold the upper thread lightly with your left hand. And its pressure drops to " 2 " when sewing appliques, mesh fabrics and embroidery. As for chiffon, lace, yarn and other miscellaneous fine materials, you may put the dial to " 3 ". 5 - 4 (3) presser foot for needlework: zigzag (4) pressure of thread tension disc: 2-6 Raise presser foot and put cloth beside leg wire of needle plate. Turn forward the balance wheel and lower the needle down into the fabric. Lower presser foot and make sure that thread is placed backward. Fabric will go along leg wire and is carned forward automatically by feed dog. In order to make end of thread firm, please press the reverse stitch buton and do several reverse stitches. Raise presser foot extract fabric and pull the thread backward. Leave certain length of thread for future use. Stop the machine, and turn the balance wheel to bring the needle down into the fabric. Lower the presser foot to resume sewing. [. . . ] Cut out the buttonhole carefully with a buttonhole cutter. Raise the foot plate of buttonholes sewing hang the laid in threads on the cam at the back of presser foot, (1) Positioning cam 2. Draw forward the end of additional thread under the presser foot and place it under the center of presser foot. Bring the neddle into the fabrics before starting sewing and lower the presser foot. [. . . ]