User manual AEG-ELECTROLUX 7250K

[. . . ] Along with a wide range of accessories designed and built to the high quality standards you would expect, from specialist cookware to cutlery baskets, from bottle holders to delicate laundry bags. The following symbols are used in this user manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. For your safety and correct operation of the appliance, read this manual carefully before installation and use. Always keep these instructions with the appliance even if you move or sell it. [. . . ] Make electrical mains terminal free of voltage. install correctly to give anti-shock protection. Loose and incorrect mains plug and socket connections can make the terminal become too hot. Use the correct mains connection cable and replace the damaged mains cable with proper special cable. The appliance must have the electrical installation which lets you disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm. You must have correct isolation devices: line protecting cut-outs, fuses (screw type fuses removed from the holder), ground leakage trips and contactors. Manufacturer is not responsible for any injury to persons and pets or damage to property caused by failure to obey these requirements. Before the installation, note down the serial number (Ser. The following instructions about installation, connection and maintenance must be carried out by qualified personnel in compliance with standards and local regulations in force. Make sure that during the installation the appliance is not connected to electrical supply. Make sure that there is a stop tap assembled between the gas supply of house and the appliance. ­ If you change from liquid gas to natural gas 20 mbar, undo the by-pass screw approximately 1/4 of a turn. Make sure the flame does not go out when you quickly turn the knob from the maximum position to the minimum position. Ground the appliance according to safety precautions. ⷠMake sure that the rated voltage and type of power on the rating plate agree with the voltage and the power of the local power supply. ⷠThis appliance is supplied with a mains cable. ⷠAny electrical component must be installed or replaced by the Service Force Centre technician or qualified service personnel. Make sure that there is an access to the mains plug after installation. The appliance must not be connected with an extansion cable, an adapter or a multiple connection (risk of fire). Check that the ground connection is in conformity with the standard and regulations force. ⷠThe power cable must be placed in such a way that it does not touch any hot part. ⷠConnect the appliance to the mains with a device that lets to disconnect the appliance from the mains at all poles with a contact opening width of minimum 3 mm, eg. [. . . ] If after some tries the burner does not light, check if the crown and its cap are in correct positions. Do not keep the control knob pushed for more than 15 seconds. If the burner does not light after 15 seconds, release the control knob, turn it into off position and try to light the burner again after minimum 1 minute. In the absence of electricity you can ignite the burner without electrical device; in this case approach the burner with a flame, push the relevant knob down and turn it counter-clockwise to maximum gas release position. [. . . ]