User manual AEG-ELECTROLUX 7388KG0

[. . . ] Please note the model number and serial number located on the inside of your refrigerator. If a problem arises, both of these numbers will be required to obtain service. Felicitaciones por la compra de su nuevo refrigerador. Con el debido cuidado, le dar muchos aos de excelente servicio. [. . . ] A RED light will appear above the Padlock. To Unlock - Press the "Padlock" pad for 3-5 seconds until the RED light above the Padlock goes out. Ice & Water Dispenser WATER CONNECTION: CAUTION: Ensure that the ice maker water supply tube is connected to a safe (potable) water pipe only. CAUTION: Water supply must have a minimum pressure of 1. 4 bars (20 psi) and a maximum pressure of 6. 9 bars (100 psi). Ice & Water Filter The filter cartridge has already been installed in the filter housing at the factory. Refer to the "ICE AND WATER DISPENSER" Section to properly fill the system with water. CHANGING THE FILTER: Water quality varies throughout the world. To ensure the highest possible water quality, change the filter every 6 months or 1514 liters. The Filter Status light will rurn RED aftre 1514 liters of water has flowed through the ice and water dispenser. Also, if filter has been in a refrigerator that has not been in use for awhile (during moving for example), change filter before reinstalling refrigerator. NOTE: Dispenser system will also operate without filtration (with filter cartridge removed). CHANGE WATER FILTER INDICATOR (some models) The Change Filter Indicator Light will light up each time the dispenser is used. The following Filter Light Indications are: Green - the filter is still operating within its specified cycle. Amber - The filter has reached approximately 80% of its useful life. Replace new cartridge, installing the same way as the old one came out. When the cartridge is almost in, you will feel it stop against the clip assembly in the back of the housing. The clip assembly holds the filter cartridge firmly in place. At this point, you will need to push firmly until the cartridge snaps fully in place. When completely in place, the front of the filter cartridge will be flush with the front of the housing. Set the ice maker wire signal arm to the ON (down) position. There will be noticable spurts and sputters as the system pushes the air out through the system and out the dispenser nozzle. After you have run one glass of water, continue to flush the system for approximately 3 minutes. Resetting The Filter Status Light (some models) After replacing the filter cartridge, it will be necessary to press the Filter Reset touchpad located on the ice and water dispenser. This will reset the Change Filter Indicator. Push the reset button until the green light flashes (3-15 seconds). TO CHANGE FRONT FILTER: (some models) Refer to Figure 4 as needed. [. . . ] This will make it easier to realign doors when they are replaced. Remove top hinge and lift refrigerator door off bottom hinge pin. Reverse this procedure to reinstall refrigerator door. When both doors have been reinstalled, replace toe grille and plug in electrical power cord. [. . . ]