User manual AEG-ELECTROLUX 7509D-W

[. . . ] When the cooker hood and appliances supplied with energy other than electricity are simultaneously in operation, the negative pressure in the room must not exceed 0, 04 mbar in order to avoid a return of the gas emissions. the air inlet must have a 500-600 cm2 surface. Should you have any problem, it is advisable to seek the advice and consent of the competent area chimney-sweeper or the local building authorities. Since in rooms without non-electric appliances the rule is the following: "Air inlet must be as large as the air outlet, the good working of the cooker hood could be reduced if the air outlet is bigger than 500-600 cm2. [. . . ] If the cabinet is without bottom 2), fix the two brackets at a distance B of minimum 30mm and maximum 60mm. Before carrying out the installation, the wooden transportation protections screwed on the visor and on the canopy body must be removed. Make a hole on the lower part of the cabinet for the duct outlet or leave the cabinet open 4). Remove the metal filters and ensure that the butterfly quick fixing clamps are completely open. Fit the cooker hood in the cabinet until it is well fixed to the butterfly quick fixing system placed on the lower part of the cabinet or on the two brackets. The lower visible part of the cooker hood can be adjusted (max 20mm) for the horizontal alignment with the cabinet. Partially loosen the four screws fixing the lower part of the cooker hood to the upper part 1), adjust the lower part of the cooker hood 2) in the desired position and tighten the screws definitively. Connection to the evacuation duct may be realised through a round or flat duct. Fix the lower part to the cabinet using five supplied screws. If you wish to replace the factory fitted front strip with a wooden one or with a front strip made with the same material as the kitchen, remove the five screws. If the cooker hood is to be installed in recirculation mode then charcoal filters (on request) must be provided. the charcoal filter is to be used only in recirculation mode. You should use only AEG original filters (see Special Accessories). the charcoal filter cannot be cleaned or regenerated. It should be replaced every 8 months if the hood is used normally. to replace the charcoal filters push the metal retaining clips inwardly. To order the spare filters, you should state the reference, the model and the product number of the cooker hood. These data are shown on the rating plate inside the hood. The charcoal filters can be ordered at AEG After Sales Service. Leave the metal filter in warm water with mild detergent for one hour and then rinse with warm water. the operation should be repeated if necessary. The filter can be refitted after having ensured it is completely dry. [. . . ] Charcoal filter KF 7509 Wall box MKZ Outside dimensions for the hole on the wall Evacuation duct 120 mm Ø Aluminium Evacuation duct 125 mm Ø Aluminium E. Attention: To clean the cooker hood disconnect the appliance from the mains supply. Do not insert any sharp object in the motor protection grille. Clean the outside parts of the cooker hood with mild detergent. [. . . ]