User manual AEG-ELECTROLUX 75301K-MNW46

[. . . ] 75301K Glaskeramik-Kochfeld Ceramic glass hob Encimera de vitrocerámica Montage- und Gebrauchsanweisung Installation and Operating Instructions Instrucciones para el montaje y para el uso Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Information concerning your personal safety. [. . . ] If you again wish to switch on a cooking zone on which hot items are already standing, you should always select the required heat setting with the - sensor field. In this way you can avoid making the food boil over as a result of the extra burst of heat from the automatic warm up. Cooking without the Automatic Warm up Function If you wish to use the cooking zone without automatic warm up, select the required heat setting with the - sensor field. Switch on the appliance and select the desired cooking zone using the cooking zone selection buttons. Touch sensor field - to select the required heat setting from 9 to 1. 3 You can adjust the heat setting at any time using the + and - buttons, providing the cooking zone has been selected. Select the desired cooking zone using the cooking zone buttons. Press the + and - buttons simultaneously to switch off. When the rings are still hot cooking should be carried out without automatic warm up. 1 54 Timer A cooking duration can be set with the integrated timer for all cooking zones. When the end of the cooking duration is reached, the cooking zone switches itself off automatically. Using the cooking zone sensor field, select the required cooking zone and set the required heat setting. Touch the TIMER W sensor field to activate the timer function for this cooking zone. Using the + or - sensor fields set or adjust the required period of time until the zone is to switch off automatically (eg. 15 minutes). After a few seconds the timer will start automatically and will show how much time remains before it will switch off. In addition, the "Timer active" display for the relevant cooking zone will light up. At the end of the set cooking time, the cooking zone will switch off automatically and an acoustic signal will sound. Touch the TIMER W sensor field to switch off the signal and control indicator. 55 3 To set the timer more quickly, leave your finger on the + or - sensor field until the required time is reached. If the - sensor field is operated first, the time setting will begin at 99 minutes; if the + sensor field is operated first, the time setting will begin at 1 minute. Displaying the remaining cooking time If you select a cooking zone which is in timer mode, the cooking time still remaining appears in the timer display window. Using the timer to measure short periods of time ("Minute Minder"). None of the cooking zones should be set with the Timer! 1. Touch the "On/Off" sensor field for around two seconds. Touch the TIMER W sensor field to activate the Timer function. Using the + or - sensor fields, set the desired length of time (for example, 20 minutes). The Timer begins to run after a few seconds, and indicates the time remaining. When the set time has elapsed, an audible signal is sounded. [. . . ] The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cutout, earth leakage tripsorfuse. A type H05VV-F cable or one with a higher grade must be used as the mains connecting cable. The connection must be carried out as shown in the diagram. [. . . ]