User manual AEG-ELECTROLUX 75580G-M

[. . . ] 75580G-M 79580G-B GB instruction booklet gas hob 2 Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read thisinstruction manual carefully. It will enable you to navigate all processes perfectlyand most efficiently. To refer to this manual any time you need to, we recommendyou to keep it in a safe place. [. . . ] 1 page 7 - B) are not obstructed. 11 Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM There is no spark when lighting the gas. SOLUTION Check that the unit is plugged in and the electrical supply is switched on. Check that the RCCB has not tripped (if fitted). Check the burner cap and crown have been replaced correctly, e. g. after cleaning. The gas ring burns unevenly. Check the main jet is not blocked and the burner crown is clear of food particles. Check the burner cap and crown have been replaced correctly, e. g. after cleaning. If after all these checks, your hob still does not operate correctly, contact your local Service Force Centre. Please note that it will be necessary to provide proof of purchase for any in-guarantee service calls. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. 12 Technical data Engineer technical data OVERALL DIMENSIONS Glass cooktop models: Width: 740 mm Depth: 510 mm Stainless steel models: Width: 745 mm Depth: 515 mm CUT OUT DIMENSIONS Width: Depth: 560 mm 480 mm SUPPLY CONNECTIONS Gas: R 1/2 inch (1/2 inch male) Rear right hand corner Electric: 230 V~ 50 Hz supply, 3 core flexible cable with non rewireable plug fitted with a 3 amp cartridge fuse. HEAT INPUT Rear Middle Burner (semi rapid) Rear Right Burner (semi rapid) Front Right Burner (semi rapid) Left Burner (triple crown) Front Middle Burner (auxiliary) APPLIANCE CLASS APPLIANCE CATEGORY GAS SUPPLY 1. 9 kW (6485 BTU/HR) 1. 9 kW (6485 BTU/HR) 1. 9 kW (6485 BTU/HR) 3. 8 kW (12970 BTU/HR) 1. 0 kW (3413 BTU/HR) 3 II2H3+ Natural gas G20 (2H) 20 mbar 13 Gas burners BURNER SEMI-RAPID MAX MIN AUXILIARY MAX MIN TYPE OF GAS POSITION NOMINAL THERMAL POWER kW NOMINAL FLOW RATE m3/h NOZZLE REFERENCE 1/100 mm NOMINAL THERMAL POWER kW NOMINAL FLOW RATE g/h NOZZLE REFERENCE 1/100 mm TRIPLE CROWN MAX MIN NATURAL GAS 20 mbar VALUE = 37. 78 MJ/m3 Ws - 50. 7 MJ/ m3 1. 9 0. 45 1. 0 0. 33 3. 8 1. 2 0. 181 0. 043 9 6 Adjust. 0. 095 0. 031 0. 362 0. 114 70 Adjust. 14 6 Adjust. LPG GAS 28-30/37 mbar VALUE = 49. 92 MJ/Kg 1. 9 1 38 71 0. 45 32. 4 32 1. 0 73 50 0. 33 23. 8 28 3. 8 2 76 98 1. 2 87 56 By-pass diameters Burner Dia. Tap By-pass 1/100 mm Auxiliary 28 Semi-rapid 32 Triple Crown 56 Aeration adjustment none 14 Important Safety Requirements This hob must be installed in accordance with the Gas Safety (Installation and Use) Regulations (Current Edition) and the IEE Wiring Regulations (Current Edition). For appliances installed in the Republic of Ireland please refer to NSAI- Domestic Gas Installation I. S. 813 Current Editions and the ETCI Rules for Electrical Installations. Provision for Ventilation Detailed recommendations are contained in the following British Standards Codes Of Practice: B. S. The hob should not be installed in a bed sitting room with a volume of less than 20 m3. If it is installed in a room of volume less than 5 m3 an air vent of effective area of 100 cm2 is required. If it is installed in a room of volume between 5 m3 and 10 m3 an air vent of effective area of 50 cm2 is required, while if the volume exceeds 11 m3 no air vent is required. However, if the room has a door which opens directly to the outside no air vent is required even if the volume is between 5 m3 and 11 m3. If there are other fuel burning appliances in the same room, B. S. 5440 Part 2 Current Edition, should be consulted to determine the requisite air vent requirements. For appliances installed in the Republic of Ireland please refer to the NSAI- Domestic Gas Installation I. S. 813 Current Editions Table Four. 15 IMPORTANT This hob must be installed by a competent person to the relevant Gas Standards. Any gas installation must be carried out by a registered competent person. [. . . ] The pressure reading should be nominally 20 mbar and must be between 17 mbar and 25 mbar. 4) Turn off the burner supplies. 25 Conversion from Natural Gas to Liquid Gas IMPORTANT The replacement/conversion from natural gas to LPG should only be undertaken by a competent person. It is important to note that this model is designed for use with natural gas but can be converted for use with butane or propane gas providing the correct injectors are fitted. The gas rate is adjusted to suit. Method 1) Ensure that the gas taps are in the 'OFF' position 2) Isolate the hob from the electricity supply 3) Remove all pan supports, burner caps, rings, crowns and control knobs. 4) With the aid of a 7mm box spanner the burner injectors can then be unscrewed and replaced by the appropriate LPG injectors. TO ADJUST THE GAS RATE With the aid of a thin bladed screwdriver completely tighten down the by pass adjustment screw. [. . . ]