User manual AEG-ELECTROLUX 78031K-IN

[. . . ] And please pass it to any future owner of the appliance. We wish you much joy with your new appliance. Contents Operating the appliance Safety Information Description of the appliance Operating the appliance Tips on cooking and frying Cleaning and care 2 2 4 6 12 14 Subject to change without notice What to do if . . . Disposal Installation instructions Safety information Service 14 16 17 17 19 Operating the appliance Safety Information WARNING!If you do not, any damage resulting is not covered by the warranty. [. . . ] Control Panel Display The length of time that the automatic warm up function operates depends on the heat setting selected. Heat setting Length of the automatic warm up [min:sec] 0:12 8 Operating the appliance Heat setting Length of the automatic warm up [min:sec] 0:12 1:21 3:07 4:24 5:51 8:12 10:12 10:36 2:01 2:01 2:28 2:52 --- Using the child safety device The child safety device prevents unintentional use of the appliance. Switching on the child safety device Step 1. Touch for 4 seconds Control panel Switch on appliance. Display/Signal The child safety device is switched on. Switching off the child safety device Step 1. Touch Control panel Switch on appliance. for 4 seconds lights up Switch appliance off. Display/Signal The child safety device is switched off. The child safety device can only be switched on and off if no heat setting is set. Overriding the child safety device The child safety device can be switched off in this way for a single cooking session; it remains activated afterwards. Operating the appliance Step 1. Touch Control panel Switch appliance on for 4 seconds lights up Display/Signal 9 Until the appliance is next switched off, it can used as normal. After switching off the appliance, the child safety device is active again. After overriding the child safety device, a heat setting or a function must be set within approx. 10 seconds, otherwise the appliance automatically switches itself off. Switching the power function on and off The power function makes more power available to the induction cooking zones, e. g. a little water on an induction cooking zone set to the highest heat setting is heated within a short time. a magnet sticks to the bottom of the cookware. Certain cookware can make noises when being used on induction cooking zones. These noises are not a fault in the appliance and do not affect operation in any way. Bottom of the cookware The bottom of the cookware should be as thick and level as possible. Pan size Induction cooking zones adapt automatically to the size of the bottom of the cookware up to a certain point. However the magnetic part of the bottom of the cookware must have Tips on cooking and frying 13 a minimum diameter depending on the size of the cooking zone. Cookware with a bottom with a diameter of less than 12cm is not suitable. Tips on energy saving Place cookware on the cooking zone before it is switched on. If possible, always place a lid on the cookware. Examples of cooking applications The information given in the following table is for guidance only. Heat setting 0 1 1-3 Cooking process suitable for Off position Keeping food warm Keeping cooked foods warm Melting Hollandaise sauce, melting butter, chocolate, gelatine Fluffy omelettes, baked eggs as required 5-25 mins. Cover Stir occasionally Cook time Tips/Hints 1-3 3-5 Solidifying Simmering 10-40 mins. Cook with lid on Add at least twice as much liquid as rice, stir milk dishes part way through cooking With vegetables add only a little liquid (a few tablespoons) Use only a little liquid, e. ¼ l water for 750 g of potatoes Up to 3 l liquid plus ingredients Turn halfway through cooking Simmering rice and 25-50 mins. [. . . ] The minimum distances to other appliances and units are to be observed. Anti-shock protection must be provided by the installation, for example drawers may only be installed with a protective floor directly underneath the appliance. The cut surfaces of the worktop are to be protected against moisture using a suitable sealant. The sealant seals the appliance to the work top with no gap. [. . . ]