User manual AEG-ELECTROLUX 79553G-M

[. . . ] ENGLISH Important Safety Information These warnings are provided in the interest of safety. You MUST read them carefully before installing or using the appliance. During Operation · · · · This appliance has been designed for non professional purpose in private houses only. It is meant to cook edible foodstuff only and MUST NOT be used for any other purposes. It is dangerous to alter the specification in any way. [. . . ] 2 FO 2110 45 Should the hob top become heavily soiled, it is recommended that a proper cleaning product is used. The electric ignition is obtained through a ceramic "candle" and a metal electrode (fig. Keep these components well clean, to avoid difficult lighting, and check that the burner crown holes (lett. A) are not obstructed. Pan Supports To keep the pan supports in the correct position, they are mounted on metal pins located in the back of the hob. To ensure a better cleaning, pan supports can be removed from the hob. Lift up the pan suports keeping them in horizontal position as shown in fig. Avoid lifting the pan supports at an angle, as this will put strain on the metal pins. This may damage the pins and cause them to break. After cleaning the hob, ensure the pan supports are properly placed as shown in fig. If washing them by hand, take care when drying them as the enamelling process occasionally leaves rough edges. If necessary, remove stubborn stains using a paste cleaner. Pay attention when placing the pan supports back on their position, in order to avoid scratching the glass hob top. YES NO Fig. 3 Periodic maintenance Periodically ask your local Service Centre to check the conditions of the gas supply pipe and the pressure adjuster, if fitted. To ensure the good operation of the hob and its safety features, it is necessary that the taps are periodically lubricated. $ The periodic lubrication of the taps must be carried out by qualified personnel, which you must refer to also in case of malfunctioning. 4 46 Something Not Working? If the hob is not working correctly, please carry out the following checks before contacting your local Service Force Centre. SYMPTOM % SOLUTION & & There is no spark when lighting the gas Check the mains fuse has not blown Check the burner cap and crown have been replaced correctly, e. g. Check the main jet is not blocked and the burner crown is clear of food particles. Check the burner cap and crown have been replaced correctly, e. g. after cleaning. % The gas ring burns unevenly & & 47 Instruction for the Installer $ $ $ $ The following instructions about installation and maintenance must be carried out by qualified personnel in compliance with the regulation in force. The regulation to be applied for this type of installation is NBN D 5I. 003 : "Installations functioning with combustible gas lighter than air". The side walls of the unit in which the hob is going to be installed, must not exceed the height of the working top. Avoid installing the appliance in the proximity of inflammable materials (e. g. The appliance must be electrically disconnected before all interventions. [. . . ] 9 - a These hobs can be inserted in a built-in kitchen unit whose depth is between 550 and 600 mm. The edge of the cut out must have a minimum distance from the rear wall of 55 mm. If there are side walls, or sides of the furniture unit near the hob, the cut out edges must have a minimum distance of 150 mm. Hanging forniture units or hoods must be placed at 650 mm. [. . . ]