User manual AEG-ELECTROLUX 8160D-M-GB

[. . . ] 8160 D/8190 D 8260 D/8290 D 8360 D/8390 D 8361 D/8391 D Cooker Hood Campana extractora Exaustor Operating and Installation Instructions Instrucciones de montaje y manejo Manual de Instruções Contents Safety warnings . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 For the user . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 For the installer . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] · Optionally, the position of the chimney elements can be changed. When using the hood in the filter version the chimney must be fixed at the top, with the air outlet grill at the side. Fig. 2 5 Control Panel · Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit's front panel: 8160 D - 8190 D · the light switch switches the hood lamp on and off · the motor switch switches the motor on and off, enabling you to select one of the three different speeds. Light switch Motor switch 8260 D - 8290 D · · · · · the light switch switches the hood lamp on and off the motor switch switches the motor off Speed 1: Speed 1 push-button Speed 2: Speed 2 push-button Speed 3: Speed 3 push-button Light switch Motor switch 6 Speed 1 Speed 2 Speed 3 Control Panel 8360 D - 8361 D - 8390 D - 8391 D · Best results are obtained by using a low speed for normal conditions and a high speed when odours are more concentrated. Turn the hood on a few minutes before you start cooking, you will then get an under pressure in the kitchen. The hood should be left on after cooking for about 15 minutes or until all the odours have disappeared. The control switches are located on the unit's front panel: A B C D E F G Mains switch, OFF. Start and choice of motor speed 1-2-3-1-2. . . . . . . . . Indicates speed 2 (LED) Indicates speed 3 (LED) Indicates Intensive speed (LED). The Intensive speed runs for 5 minutes: If the hood is on when the Intensive speed is activated, the hood reverts to previous speed after 5 minutes. If the hood is off when the Intensive speed is activated, the hood will be turned off after 5 minutes. To interrupt the Intensive speed, press button A or B. H - Light ON/OFF - Should the hood or the controls fail to operate: disconnect the power supply for at least 5 seconds, then turn the hood back on again. 7 Maintenance and care · The hood must always be disconnected from the electricity supply before beginning any maintenance work. Cleaning the hood · Clean the outside of the hood using a damp cloth and a mild detergent. · Never use corrosive, abrasive or flammable cleaning products. · Never insert pointed objects in the motor's protective grid. · Wash the outside surfaces using a delicate detergent solution. Never use caustic detergents or abrasive brushes or powders. · Only ever clean the switch panel and filter grille using a damp cloth and delicate detergents. · It is extremely important to clean the unit and change the filters at the recommended intervals. Failure to do so will cause grease deposits to build up that could constitute a fire hazard. Metal grease filter · The purpose of the grease filters is to absorb grease particles which form during cooking and it must always be used, either in the external extraction or internal recycling function. [. . . ] 12 Technical Details Models Dimensions (in cm) Maximum Motor Height Width Depth absorbed power power Lighting Length Electrical of the cable connection 8160 D 80-135 59, 8 8190 D 82-137 89, 8 8260 D 80-135 59, 8 8290 D 82-137 89, 8 8360 D 80-135 59, 8 8390 D 82-137 89, 8 8361 D 80-135 59, 8 8391 D 82-137 89, 8 47 48 47 48 47 48 47 48 170 W 170 W 200 W 200 W 175 W 175 W 175 W 175 W 1 x 155 W 1 x 11 W (PL) 1 x 155 W 1 x 11 W 150 cm 150 cm 220-240 V 220-240 V 220-240 V 220-240 V 220-240 V 220-240 V 220-240 V 220-240 V 1 x 155 W 2 x 20 W (G4) 150 cm 1 x 155 W 2 x 20 W (G4) 150 cm 1 x 130 W 2 x 20 W (G4) 150 cm 1 x 130 W 2 x 20 W (G4) 150 cm 1 x 130 W 2 x 20 W (G4) 150 cm 1 x 130 W 2 x 20 W (G4) 150 cm Mounting accessories included 6 wall plugs Ø 8 mm (brick fixing only) 6 wood-screws 5 x 45 mm 2 metal screws 2, 9 x 13 4 metal screws 2, 9 x 6, 5 5 metal screws 3, 5 x 13 2 hooks 1 chimney support 2 clamps 1 deflector 1 reduction flange Ø 150-125 mm 1 charcoal filter frame 1 allen spanner 13 Electrical connection (not for UK) Safety warnings for the electrician Before connecting the appliance to the power supply, check that the voltage indicated on the rating plate corresponds to the mains power supply available. Appliances fitted with a plug can be connected to any standard power socket within easy access. Should it be necessary to provide a fixed connection, the hood must only be installed by an electrician authorised by the local electricity board. When installing, an omnipolar disconnector with a distance of at least 3 mm between contacts must be provided. [. . . ]