User manual AEG-ELECTROLUX 8260D-M

[. . . ] 11 Safety instructions These warnings are provided in the interest of your safety. Ensure that you understand them all before installing or using the appliance. If you are unsure about any of these meanings or warnings contact the Customer Care department Please retain this instruction book for future reference, particularly if the appliance is sold or left to another person. Installation and service q q q q q Any electrical installation of the cooker hood must be carried out by a qualified electrician and the hood itself must be installed by someone with experience. Installation made by an unqualified person can lead to loss of function of the cooker hood and possible damage to person and and/or property. The cooker hood must be at least 50 cm above electric hobs or electric ranges, or at least 65 cm above gas burners or gas ranges. [. . . ] The filter is made of aluminium wires on which the grease collects. Clean the filter in hot water using a detergent, or in a dishwasher. Let the filter dry before putting it back. Note that a dishwasher may discolour the filter. Fig. 3 Changing and cleaning the carbon filter Only applicable for recirculation. The carbon filters absorb smells and odours. Unlike other carbon filters, the LONGLIFE carbon filter can be cleaned and reactivated. At normal use the filter should be cleaned every second month. The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65º C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100º C. The KFL 60/80 carbon filter can not be reactivated, it has to be changed after 6-8 months of normal use. 5 After approximately three years of use, the KF8 filter should be replaced with a new, as the odour reduction capacity will be reduced. q Press the red buttons (A), lower the front of the carbon filter. The grease that collects in the filters and the duct could ignite if a hot plate is left on (or if overheating occurs). Changing the light Disconnect the cooker hood from the main supply before changing the light. 5): q Press (1) the lamp cover (2) and open it. q Replace the old bulb with a new one of the same type (3). 5 6 What to do if If your appliance fails to work properly please carry out the following checks. Symptom The cooker hood will not start. . . Solution The hood is connected to the electricity supply. Check that the fan speed control is set to 1, 2 or 3. The fan speed is set high enough for the task. [. . . ] 942 118 609 610 899 421 10 Installation Unpacking Check that the cooker hood is not damaged. Transportation damages should immediately be reported to the transport company. Be careful that it is centered over the hood and horizontally aligned. Fitting for ducting (S) Connect a tube between the hood air outlet and the wall or roof exhaust channel. Fix it with the tube clamps supplied. Fitting for recirculation (K) Mount the recirculation spigot with the two screws supplied. Mounting the chimney Place the chimney (15) and fix it to the top chimney holder with the two screws (16) supplied. [. . . ]