User manual AEG-ELECTROLUX 855D-M

[. . . ] â· To prevent scale deposits from forming, always thoroughly dry the appliance after going over it with a damp cloth. â· Immediately remove any foods with high sugar content that spill onto the hob. The grates, burner caps and flame-spreaders can be removed from the hob and cleaned with hot soapy water, thoroughly drying them afterwards. Make sure the gas outlet zones are perfectly clean. [. . . ] If you move to any of the countries listed below, also the appliance warranty will be transferred with the following conditions: The appliance warranty starts from the date of first purchase, which must be proven by showing a valid purchase document issued by the seller. Labour and/or replacement parts) shall refer to the conditions existing in the new country of residence for the same type of products. The warranty is strictly personal and is in the name of the original appliance purchaser and cannot be transferred to another user. The appliance must be installed and used in compliance with the instructions supplied by Electrolux, only for domestic use and in any case not for business or professional activities. The appliance must be installed in compliance with all the current regulations in the new country of residence. The provisions of the European Guarantee do not prejudice the owner's rights according to the law. Always contact qualified personnel in the following cases: - immediately after unpacking, in case of doubts about the integrity of the appliance; - replacing or damaged power cable; - appliance malfunction or poor operation, requesting original replacement parts. To ensure safe and efficient operation of this appliance: - only contact authorised service centres; - always demand the use of original replacement parts; - the appliance is designed for non-professional, domestic use; do not modify its characteristics; - the dataplate gives the symbols indicating the countries for which the instructions apply; - appliance electrical safety is guaranteed only when it is connected to an earthing system in compliance with the current regulations; - do not touch the pot grids during use, since they become very hot. Keep children away from the appliance; - only use the appliance for cooking food; - before any cleaning or maintenance operations, or in case of malfunction, disconnect the appliance from the mains power supply; - always check that the control knobs are in the off position when the appliance is not in use. Do not allow children to touch: the controls or the appliance in general; the packing components (bags , polystyrene , staples , etc. ); the appliance, during and immediately after use, since the hob becomes very hot; an unused appliance (make any potentially hazardous parts safe). The opening must be made in the most convenient position, taking into account that the gas pipe must not come into contact with the sides of a possible electrical appliance installed under the hob. â· After carrying out the necessary connections, spread the silicone sealant around the opening, at the milling, and position the hob. Before connecting the appliance to the gas supply, in compliance with the current regulations, make sure it is arranged for the type of gas to be used. Otherwise, carry out the operations described in the section "Replacing injectors" (page 17). For liquefied gas, use pressure regulators complying with the current regulations. Connection to the gas pipe can be carried out in two ways: gasket gasket flexible steel A Connect the gas hob using a 12 mm diameter rigid copper pipe, as tube shown in fig. To ensure a good seal, fit the elastomer gasket supplied as an accessory (standard UNI EN 682). b Connect the hob using a continuous-surface flexible steel tube (standard UNI 9891). Also in this case, to ensure a good seal use the gasket supplied as an accessory. After carrying out the connection use soapy water to check for any leaks. Make sure the room where the appliance is installed has permanent ventilation openings towards the outside or ventilation ducts to ensure an adequate air flow, as prescribed by the current regulations. [. . . ] 5 mm2 H05VV-F type cable is used when replacing the power cable; g) to respect the polarities of the free terminals (Brown=Line Blue=Neutral Yellow/Green=Earth). NB: Make sure the characteristics of your household electrical system (voltage, max. Power and current) are compatible with those of your AEG hob. If a different type of gas is to be used, change the injectors as follows: 1. [. . . ]