User manual AEG-ELECTROLUX 865D-M

[. . . ] and please pass it to any future owner of the appliance. We wish you much joy with your new appliance. Subject to change without notice If you do not, any damage resulting is not covered by the warranty. correct use · This appliance is not intended for use by children or other persons whose physical, sensory or mental capabilities or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction by a responsible person to ensure that they can use the appliance safely. [. . . ] Control panel To set the heat setting Switch off Touch the desired heat setting, if necessary, correct up or down Touch / Display to Switching the outside ring on and off By switching the outside rings on or off, the effective heating surface can be matched to the size of the cookware. Before an outside ring can be switched on, the inside ring must be switched on Double ring zone To switch on outside ring To switch off outside ring Touch Touch Sensor field for 1-2 seconds for 1-2 seconds Pilot light Second pilot light lights up Second pilot light goes out Triple cooking zone To switch on the central ring To switch on the outside ring To switch off the outside ring To switch off the central ring Multi-purpose zone To switch on outside ring To switch off outside ring Touch Touch Touch Touch Touch Touch Sensor panel for 1-2 seconds. Sensor field for 1-2 seconds for 1-2 seconds Pilot light Second pilot light lights up Third pilot light lights up Third pilot light goes out Second pilot light goes out Pilot light Second pilot light lights up Pilot light goes out The control panel, with the exception of the "On/Off" sensor field, can be locked at any time in order to prevent the settings being changed e. Control panel To switch on To switch off Touch Touch (for 4 seconds) previously set heat setting Display When you switch the appliance off, the locking function is automatically switched off. Turning the STOP+GO function on and off The STOP+GO function simultaneously toggles all active cooking zones to keep-warm mode then back to the heat setting they were at before Control panel To switch on To switch off Touch Touch Previous heat setting (not automatic warm-up or power function) Display STOP+GO controls the entire control panel apart from the sensor field . All cooking zones are equipped with an automatic warm-up function. When setting a heat setting using the automatic warm-up function, the cooking zone switches to full power for a certain amount of time and then automatically switches back to the heat setting set. Control Panel Move your finger down from to select the desired heat setting between and Display / after 5 seconds . as long as is displayed , the appliance works at full power. After the automatic warm up is completed, the heat setting / is displayed again. The length of time that the automatic warm up function operates depends on the heat setting selected. When the appliance is switched off, if one or more of the sensor fields on the control panel are covered for more than 10 seconds, an acoustic signal sounds. The acoustic signal switches itself off automatically when the sensor fields are no longer covered. cooking zones · If one of the cooking zones is not switched off after a certain time, or if the heat setting is not modified, the relevant cooking zone switches off automatically. Before being used again, the cooking zone must be set to . Heat setting Switches off after 6 hours 5 hours 4 hours 1. Information about acrylamides According to the latest scientific research, intensive browning of food, especially in products containing starch, may present a health risk due to acrylamide. Therefore we recommend cooking at low temperatures and not browning foods too much. You can recognise good cookware from the bottoms of the pans. Cookware made of enamelled steel or with aluminium or copper bottoms can leave discolorations on the glass ceramic surface which are difficult or impossible to remove. Always place cookware on the cooking zone before it is switched on. if possible , always place lids on the pans. [. . . ] place a scraper on the glass ceramic surface at an angle and remove residues by sliding the blade over the surface. Wipe the appliance with a damp cloth and a little washing up liquid. Finally, rub the appliance dry using a clean cloth . Limescale rings, water rings, fat splashes, shiny metallic discolorations should be removed after the appliance has cooled down using cleaner for glass ceramic or stainless steel. [. . . ]