User manual AEG-ELECTROLUX 88100K-MNAEGBIG4

[. . . ] 88100K Ceramic glass induction hob Table de cuisson vetrocéramique à induction Glaskeramische inductie-kookplaat Installation and Operating Instructions Instructions de montage et mode d'emploi Montage- en gebruikshandleiding Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning: Information concerning your personal safety. [. . . ] Touch sensor fields + and - simultaneously to switch off or turn sensor field - back to zero. 3 A cooking zone may only be switched off when the decimal point is on in the cooking zone display. 20 Cooking with the Automatic Heating-Up Function All four cooking zones of the cooking field can be controlled in nine stages and have an automatic heating-up function: ­ 1, Lowest heat setting ­ 9, Highest heat setting ­ a, Heating-up function. With the automatic heating-up function (a), the cooking zone operates for a certain time at full capacity and then automatically switches back to the heat setting selected for further cooking. The duration of the automatic heating-up function depends on the heat setting selected for further cooking. Select the required cooking zone with the cooking zone sensor fields. The decimal point in the associated display field illuminates. 2. With the + or - sensor fields set the cooking stage 9. Stop briefly and touch the + sensor field again. 21 a lights up in the heat setting display. 3. Next, touch the sensor field - and set the required continued heat setting 1 to 8. The heat setting selected for further cooking then is displayed. 3 After 5 seconds, a appears in the display again instead of heat setting selected for further cooking. The heat setting is displayed again after the heating-up time has ended. If you select a higher heat setting when the automatic function is in operation, e. g. from 3 to 5, the previous heating-up time is taken into account. If you select a lower setting, then the automatic function is brought to an immediate end. If you start cooking again on a cooking zone that is still warm, the automatic heating-up function uses the residual heat. This saves time and energy. 22 Cooking without the Automatic Heating-Up Function 1. For heating up/browning, select a high power. As soon as steam forms or the fat is hot, switch back to the required heat setting for the remainder of the cooking time. Note: When cooking with the induction cooking zone you should take into account that ­ the heating-up times are reduced by the direct energy transfer to the pan!­ the cooking process stops immediately after the cooking zone is switched off (no boiling over!) 2 Locking/Unlocking the Control Panel With the exception of the "On/Off" sensor field the control panel can be locked at any required time during cooking in order to prevent adjusting the settings such as when wiping over with a cloth. This function is also suitable as a child safety feature. Touch the , , lock" sensor field until the control indicator comes on. 3 2. To release the lock touch the , , lock" sensor field again continuously until the control indicator goes out. [. . . ] The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cutout, earth leakage tripsorfuse. A type H05VV-F cable or one with a higher grade must be used as the mains connecting cable. The connection must be carried out as shown in the diagram. [. . . ]