User manual AEG-ELECTROLUX 91900KFE-N(AEG)

[. . . ] C91900KFE-N Glaskeramik-Kochfeld Glaskeramische kookplaat Taque de cuisson vitrocéramique Ceramic glass hob Montage- und Gebrauchsanweisung Montage- en gebruikshandleiding Instructions de montage et mode d'emploi Installation and Operating Instructions Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. [. . . ] To reactivate the cooking zones, the locking function must be cancelled as described above. 137 Operating Instructions Timer A cooking duration can be set with the integrated timer for all cooking zones. When the end of the cooking duration is reached, the cooking zone switches itself off automatically. Using the cooking zone sensor field, select the required cooking zone and set the required heat setting. Touch the TIMER W sensor field to activate the timer function for this cooking zone. Using the + or - sensor fields set or adjust the required period of time until the zone is to switch off automatically (eg. 15 minutes). After a few seconds the timer will start automatically and will show how much time remains before it will switch off. In addition, the "Timer active" display for the relevant cooking zone will light up, e. g. the top left control indicator corresponds to the rear left cooking zone. At the end of the set cooking time, the cooking zone will switch off automatically and an acoustic signal will sound. Touch the TIMER W sensor field to switch off the signal and control indicator. 138 Operating Instructions 3 To set the timer more quickly, leave your finger on the + or - sensor field until the required time is reached. If the - sensor field is operated first, the time setting will begin at 99 minutes; if the + sensor field is operated first, the time setting will begin at 1 minute. Displaying the remaining cooking time If you select a cooking zone which is in timer mode, the cooking time still remaining appears in the timer display window. Using the timer to measure short periods of time ("egg timer") 3 The timer function can also be used to measure short times without the automatic switch-off function, provided the timer is not already being used for 1 or more cooking zones. No cooking zone may be selected in this case. The cooking zone sensor field with the decimal point in the display must therefore be touched again so that the decimal point goes out. Set the time as described above. Ending the timer function prematurely There are two ways of switching off the timer early: Switching off the cooking zone and timer simultaneously 1. Select the desired cooking zone using the cooking zone buttons. Touch the + and - buttons simultaneously: The cooking zone and timer will switch off. Switching off the timer - leaving the cooking zone active 1. Select the desired cooking zone using the cooking zone buttons. Touch the "Timer" button again 3. Touch the + and - buttons simultaneously: ­ Only the timer will switch off. ­ The cooking zone will stay on. 139 Operating Instructions Power Management If a high heat setting (8 or 9) is set for the front left, rear right and front right cooking zones simultaneously, the hob control automatically brings about the optimal distribution of heating power. In this case the last cooking zone to be switched on takes priority and is allocated the selected heat setting 8 or 9. [. . . ] The joining point of the two ends should be in the middle of one of the sides. After cutting the correct length (allow a few millimetres) simply press the two ends against each other. 1 Remarks: If the corner joint of the working plate is connected with clamping elements, then care must be taken that at least the front ones left and righ are removed, after curing the adhesive and before installation of the cooking surface. 151 Installation Instructions Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. The heating element voltage is AC230 V ~. [. . . ]