User manual AEG-ELECTROLUX 933 E D

[. . . ] Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. For the safety of life and property keep the precautions of these user's instructions as the manufacturer is not responsible for damages caused by omission. Children and vulnerable people safety · This appliance is not intended for use by persons (including children) with reduced physical, sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision or instruction concerning use of the appliance by a person responsible for their safety. Children should be supervised to ensure that they do not play with the appliance. [. . . ] The insulation foam contains flammable gases: the appliance shall be disposed according to the applicable regulations to obtain from your local authorities. Avoid damaging the cooling unit, especially at the rear near the heat exchanger. The materials used on this appliance marked by the symbol are recyclable. CONTROL PANEL 1 2 3 4 5 6 1 2 3 4 5 6 Temperature Regulator S/N switch (Action Freeze Function) S/N light (Action Freeze Function) Pilot light High temperature alarm light I/O Switch Switching on Insert the plug into the wall socket. Move the "I/O" switch to "I" position. Turn the Temperature regulator clockwise to a medium setting. The Pilot light and the Alarm light will light up. Switching off To turn off the appliance, move the "I/O" switch to "O" position. Temperature regulation The temperature is automatically regulated. To operate the appliance, proceed as follows: · turn the Temperature regulator toward lower settings to obtain the minimum coldness. 4) If a water connection is foreseen · turn the Temperature regulator toward higher settings to obtain the maximum coldness. The intermediate position is usually the most suitable. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: · room temperature · how often the door is opened · the quantity of food stored · the location of the appliance. Never use detergents, abrasive powders, highly perfumed cleaning products or wax polishes to clean the interior as this will damage the surface and leave a strong odour. Clean the condenser (black grill) and the compressor at the back of the appliance with a brush or a vacuum cleaner. This operation will improve the performance of the appliance and save electricity consumption. Take care of not to damage the cooling system. Many proprietary kitchen surface cleaners contain chemicals that can attack/damage the plastics used in this appliance. For this reason it is recommended that the outer casing of this appliance is only cleaned with warm water with a little washing-up liquid added. After cleaning, reconnect the equipment to the mains supply. Defrosting the freezer A certain amount of frost will always form on the freezer shelves and around the top compartment. Defrost the freezer when the frost layer reaches a thickness of about 3-5 mm. About 12 hours prior to defrosting, set the Temperature regulator toward higher settings , in order to build up sufficient chill reserve for the interruption in operation. To remove the frost, follow the instructions below: 1. [. . . ] It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. 1. Dismantle the support foot (2) and the lower hinge (1) 3. Dismantle the support foot (2) and the lower hinge (1) on the opposite side. 100mm 1 2 10mm Electrical connection Before plugging in, ensure that the voltage and frequency shown on the rating plate correspond to your domestic power supply. The power supply cable plug is provided with a contact for this purpose. [. . . ]