User manual AEG-ELECTROLUX 93410 G-BN/NL

[. . . ] ⷠIf your domestic electrical circuit needs adapting to allow the appliance to be plugged in, use a qualified electrician. ⷠEnsure that, after installation, the power cable is not trapped under the appliance. ⷠIf the appliance is installed on carpeted floor, ensure that the carpet does not obstruct any ventilation ducts located at the base of the appliance. ⷠThe appliance must be equipped with an earthed power plug which conforms to regulations. [. . . ] ⷠRun an initial wash cycle at 90°C, without any washing but with detergent to clean the water tank. Load the washing, close the drum and the lid of your washing machine. Before closing the lid of your appliance, ensure that the drum is properly closed : · When the two shutters are closed, · locking button A released. Proportioning of detergents Pour the amount of washing powder into and prewash compartthe washing ments if you have selected the "prewash" option. If you turn the programme selector to another programme while a cycle is in progress, the appliance will ignore the new selected programme. At the end of the programme, if you have selected "Rinse hold" or "Night cycle" , you then need to select a "Spin" or "Drain" programme to finish the cycle and empty the water. Night cycle : the cycle contains no spin and ends with a rinse hold. Selecting options You must select the different options after selecting the programme and before presspushbutton (see ing the "Start/Pause" "Programme table"). press the desired button(s) ; the corresponding lights come on. If one of the options is not compatible with the selected programme, "Err" flashes on the dispushbutton play and the "Start/Pause" flashes red. "Prewash" option The appliance runs a prewash at 30°C max. Tion End of the programme The washing machine stops automatically ; pushbutton goes out the "Start/Pause" and "0" flashes on the display. The lid can only be opened around 2 minutes after the washing machine has come to a stop. Stand by : once the programme has finished after a few minutes the energy saving system will be enabled. the brightness of the display is reduced. By pressing any button the appliance will come out of the energy saving status. Type of fabric For heavy soiled items For normal soiled items For daily soiled items For slightly soiled items For very slightly soiled items For items used or worn for a short time For refreshing items only For refreshing a very few items only It is normal for the programme selector to remain stationary during the cycle. Normally soiled work clothes, bed linen, table linen, body linen, towels. Spin speed: 700 rpm Wool (cold - 40°) : Machine washable wool carrying the labels "pure new wool, machine washable, does not shrink". Spin speed: 900 rpm Rinse : Hand washed items can be rinsed in this programme. Spin speed: 1000 rpm Drain : Runs an empty cycle after a Rinse hold (or Night cycle ). Spin : A spin cycle from 700 to 1000 rpm after a Rinse hold (or Night cycle). [. . . ] Remove all protective packaging for transit before using for the first time. Keep in case needed for future transit: Transporting a non-secured appliance may damage internal components and cause leakages and In case of necessity move the inlet hose in the direction shown on picture no. To make this loose the inlet hose ring nut and position the inlet hose downwards as drawn on picture no. Tighten the ring nut back and make sure there are no leaks. [. . . ]