User manual AEG-ELECTROLUX 96300KA-MN

[. . . ] 96300KA-mn Ceramic Glass Cooking Surface Operating and Installation Instructions Dear customer, Please read these operating instructions carefully. Pay particular attention to the section Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. [. . . ] in order to set the You can change the setting at any time using the cooking setting selector sensor panels and . 18 Child safety lock You can use the child safety lock to safeguard against unwanted use of the cooking surface. Switching on the child safety lock To be able to switch on the child safety lock the appliance must be swit- ched on, but all the cooking zones must be switched off. three seconds. An acoustic signal will sound as confirmation. Touch any heat setting sensor field . will appear in the displays, and the child safety lock is activated. The appliance will switch itself off automatically after a few seconds. 19 Overriding the child safety lock The child safety lock can be overridden in order to use the appliance (until the appliance is switched off again). When the appliance is switched on again the child safety device is activated once again. Switch on the appliance. When the child safety device has been activated, will be displayed. Touch any two heat setting sensor fields and simultaneously. An acoustic signal will sound as confirmation. The child safety device has been overridden until the appliance is switched off, and the cooking sur- face can be used as normal. 20 Switching off the child safety lock 1. Switch on the appliance. When the child safety device has been activated, will be displayed. three seconds. An acoustic signal will sound as confirmation. Touch any heat setting sensor field . The displays will become dark, and the child safety device is switched off. The appliance will switch itself off automatically after a few seconds. 21 Timer There are two ways to use the timer: - as a safety cut-out function. Set a cooking period for a cooking zone, and after this time has elapsed the cooking zone will automatically switch itself off. This function can be used for more than one cooking zone simultaneously. - as a countdown timer without a cut-out function ("egg timer"), whereby an acoustic signal can be heard after the set period of time has elapsed. The countdown timer cannot be used if a cooking zone is switched on. Safety cut-out The cooking zone(s) for which you want to use the safety cut-out function must be switched on. Using the timer sensor panel, select the cooking zone for which the safety cut-out is to be set. By touching the timer sensor panel once the first active cooking zone is selected in a clockwise direction, and the corresponding control lamp will flash rapidly. Hereby the (e. g. ) left rear control lamp corresponds to the left will appear in the timer display. The next active cooking zone is selected by touching the timer sensor panel again. 22 2. While the control lamp is flashing rapidly, use the or timersetting sensor panels to set the desired period of time for this cooking zone up un- til the point where it automatically switches itself off (e. g. 15 minutes). The safety cut-out function will be activated after several minutes. [. . . ] · The kitchen unit in which the appliance is fitted must satisfy the require- ments of DIN 68930 in respect of stability. · Built-in ovens and cooking surfaces are fitted with special connector sy- stems. They may only be combined with appliances with a matching system. · All cut surfaces are to be sealed with a suitable sealant for protection against moisture. [. . . ]