User manual AEG-ELECTROLUX 96901KFE-N92B

[. . . ] Useful tips and hints Environmental information 2 Contents Operating Instructions. Switching the STOP+GO function on and off. 4 4 6 6 6 7 8 8 9 9 9 10 10 11 11 12 13 16 17 18 18 18 19 Cleaning and care . 31 3 Operating Instructions 1 Safety instructions 3 5 Please comply with these instructions. [. . . ] The child safety device is released. Overriding the child safety device The child safety device can be released in this way for a single cooking session; it remains activated afterwards. Touch Control panel Switch on the appliance and Display/Signal l at the same time / acoustic signal Until the appliance is next switched off, it can used as normal. Using the timer All cooking zones can use each use one of the two timer functions at the same time. Function Automatic cut-out Condition a heat setting is set Outcome after the time has elapsed acoustic signal 00 flashes Cooking zone switches off acoustic signal 00 flashes Countdown timer cooking zones not in use 3 3 If a cooking zone is switched off, the timer function set is also switched off. If a heat setting is set on this cooking zone in addition to a countdown timer, the cooking zone is switched off after the time set has elapsed. 13 Selecting a cooking zone Step 1. Control panel Touch TIMER 1x Indicator Pilot light for the first cooking zone flashes Pilot light for the second cooking zone flashes Pilot light for the third cooking zone flashes Pilot light for the fourth cooking zone flashes Pilot light for the fifth cooking zone flashes 2. Touch TIMER 1x 3. Touch TIMER 1x 4. Touch TIMER 1x 5. Touch TIMER 1x 3 3 3 The heat setting indicator of the selected cooking zone goes out, until the timer time is set. If the power indicator is flashing more slowly, the heat setting indicator appears again and the heat setting can be re-set or modified. If other timer functions are set, after a few seconds the shortest remaining time of all the timer functions is displayed and the corresponding pilot light flashes. Setting the time Step 1. Control panel field Display TIMER Select cooking Pilot light of the cooking zone sezone lected flashes Touch or for the 00 to 99 minutes cooking zone selected After a few seconds the pilot light flashes more slowly. 14 Switching off the timer function Step 1. Heat setting V, 1 - 2 3-4 5 6-9 Switches off after 6 hours 5 hours 4 hours 1. 5 hours 16 Power-Management The three cooking zones front left, front right and back right together have a maximum possible power available to them. If it looks like the maximum power of all three cooking zones is going to be exceeded, for example by turning on an additional cooking zone or by turning up a heat setting, the Power Management automatically reduces the power of another cooking zone. Wipe the appliance with a damp cloth and a little washing up liquid. Rub the appliance dry using a clean cloth. Remove Type of dirt sugar, food containing sugar plastics, tin foil limescale and water rings fat splashes shiny metallic discolorations imme- when the appliance has diately cooled down yes yes ----------yes yes yes using a scraper* cleaner for glass ceramic or stainless steel* *Scrapers and cleaners for glass ceramic and stainless steel can be purchased in specialist shops, supermarkets, the parts department of your local Service Force Centre or from www. shop. electrolux. co. uk 3 3 Remove stubborn residues with a cleaner for glass ceramic or stainless steel. Scratches or dark stains on the glass ceramic that cannot be removed do not however affect the functioning of the appliance. 20 What to do if . . . Problem The cooking zones will not switch on or are not functioning Possible cause Remedy More than 10 seconds have Switch the appliance on passed since the appliance again. was switched on The child safety device is switched on l Several sensor fields were touched at the same time Safety cut-out has been triggered Deactivate the child safety device (See the section "Child safety device") Only touch one sensor field Remove any objects that are lying on the control panel. Switch the appliance on again Switching off STOP+GO STOP+GO is activated u Acoustic signal sounds The control panel is wholly Remove objects. when appliance is switched or partly covered by oboff jects. The residual heat indicator The cooking zone was only If the cooking zone is supis not displaying anything on for a short time and is posed to be hot, call your therefore not hot local Service Force Centre. The automatic warm up function is not switching itself on There is still residual heat on the cooking zone h The highest heat setting is set Let the cooking zone cool down The highest heat setting has the same power as the automatic warm up function 1. Set the cooking zone using the sensor field The heat setting was set using the sensor field Acoustic signal sounds and The On/Off sensor field has Do not place any objects appliance switches itself on been covered up, e. g. by a on the control panel and then off again; after 5 cloth seconds another acoustic signal sounds Display changes between two heat settings _ is lit Power Management is reducing the power of this cooking zone See section "Power Management" in the chapter Operating the Appliance Overheating protection for Switch off the cooking the cooking zone has been zone. Switch the cooking triggered zone on again 21 Problem e and number are displayed Possible cause Electronics fault Remedy Disconnect the appliance from the electrical supply for a few minutes (Take the fuse out of the house's wiring system) If after switching on again, e is displayed again, call the customer service department e and minus are displayed Light rays that are too Briefly shade the control strong on the control pan- panel, for example with el, for example bright sun- the hand Acoustic signal light sounds, appliance switches itself off Switch appliance on (again) 1 3 If you are unable to remedy the problem by following the above suggestions, please contact your local Service Force Centre. [. . . ] The appliance has not been serviced, maintained, repaired, taken apart or tampered with by any person not authorised by us. All service work under this guarantee must be undertaken by a Service Force Centre. Any appliance or defective part replaced shall become the Company's property. This guarantee is in addition to your statutory and other legal rights. [. . . ]