User manual AEG-ELECTROLUX 96931KF-N

[. . . ] 96931KF-N User manual Ceramic glass hob 2 Contents Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. [. . . ] for 4 seconds lights up Switch appliance off. Display/Signal The child safety device is switched off. The child safety device can only be switched on and off if no heat setting is set. Overriding the child safety device The child safety device can be switched off in this way for a single cooking session; it remains activated afterwards. Operating the appliance Step 1. Touch Control panel Switch appliance on for 4 seconds lights up Display/Signal 9 Until the appliance is next switched off, it can used as normal. After switching off the appliance, the child safety device is active again. After overriding the child safety device, a heat setting or a function must be set within approx. 10 seconds, otherwise the appliance automatically switches itself off. Using the timer Function Automatic cut-out Condition a heat setting is set Outcome after the time has elapsed acoustic signal 00 flashes Cooking zone switches off acoustic signal 00 flashes Countdown timer cooking zones not in use If just one countdown value is set you can change it only when the appliance is switched on. If a heat setting is set on this cooking zone in addition to a countdown timer, the cooking zone is switched off after the time set has elapsed. If a cooking zone is switched off, the timer function set is also switched off. Control panel Touch Touch Touch Touch Touch once once once once once Display Pilot light of the first cooking zone flashes Pilot light of the second cooking zone flashes Pilot light of the third cooking zone flashes Pilot light of the fourth cooking zone flashes Pilot light of the fifth cooking zone flashes If other timer functions are set, after a few seconds the shortest remaining time of all the timer functions is displayed and the corresponding pilot light flashes. 10 Operating the appliance Setting the time Step 1. Select Touch or Control panel cooking zone / Display Pilot light for the cooking zone selected flashes 00 to 99 minutes After a few seconds the pilot light flashes more slowly. The time counts down. Switching off the timer function Step 1. Select Touch Control panel cooking zone Display Pilot light of cooking zone selected flashes faster Time remaining is displayed The time remaining counts backwards to 00 . The pilot light goes out. The Timer function for the selected cooking zone is switched off. Changing the time Step 1. Control panel Selecting a cooking zone Display Pilot light of the selected cooking zone flashes more quickly Remaining time is displayed 2. Touch or 01 to 99 minutes After a few seconds the pilot light flashes more slowly. The time counts down. Displaying the time remaining for a cooking zone Step 1. After one minute the actual heat setting is displayed. The following table shows the distribution of the maximum possible heat setting when all three cookning zones are on at the same time. First cooking zone 14 14 14 13 Second cooking zone 14 13 12 13 Third cooking zone 1 - 11 12 13 12 Tips on cooking and frying Tips on cooking and frying Information about acrylamides According to the latest scientific research, intensive browning of food, especially in products containing starch, may present a health risk due to acrylamide. Therefore we recommend cooking at low temperatures and not browning foods too much. Cookware · You can recognise good cookware from the bottoms of the pans. The bottom should be as thick and flat as possible. · Cookware made of enamelled steel or with aluminium or copper bottoms can leave discolorations on the glass ceramic surface which are difficult or impossible to remove. Energy saving Always place cookware on the cooking zone before it is switched on. If possible, always place lids on the pans. [. . . ] The cut surfaces of the worktop are to be protected against moisture using a suitable sealant. The sealant seals the appliance to the work top with no gap. When building in, protect the underside of the appliance from steam and moisture, e. g. Avoid installing the appliance next to doors and under windows. [. . . ]