User manual AEG-ELECTROLUX 98030KF-SN

[. . . ] and please pass it to any future owner of the appliance. We wish you much joy with your new appliance. Subject to change without notice If you do not, any damage resulting is not covered by the warranty. correct use · This appliance is not intended for use by children or other persons whose physical, sensory or mental capabilities or lack of experience and knowledge prevents them from using the appliance safely without supervision or instruction by a responsible person to ensure that they can use the appliance safely. [. . . ] Do not release before the desired heat setting is reached. If the control bar is touched for longer than 6 seconds, a signal sounds and the appliance switches itself off. Use the induction cooking zones with suitable cookware. Control panel Switch on Switch off Touch Touch for 1 second for 1 second / / none Display Pilot light lights up. 10 seconds a heat setting or a function must be set, otherwise the appliance automatically switches itself off. Control panel To set the heat setting Switch off Touch the desired heat setting, if necessary, correct to the left or the right Touch / Display to The control panel, with the exception of the "On/Off" sensor field, can be locked at any time in order to prevent the settings being changed e. Control panel To switch on To switch off Touch Touch (for 4 seconds) previously set heat setting Display When you switch the appliance off, the locking function is automatically switched off. Turning the STOP+GO function on and off The STOP+GO function simultaneously toggles all active cooking zones to keep-warm mode then back to the heat setting they were at before Control panel To switch on To switch off Touch Touch Previous heat setting (not automatic warm-up or power function) Display STOP+GO controls the entire control panel apart from the sensor field . All cooking zones are equipped with an automatic warm-up function. When setting a heat setting using the automatic warm-up function, the cooking zone switches to full power for a certain amount of time and then automatically switches back to the heat setting set. Control panel Touch Move your finger down / after 5 seconds . Function Automatic cut-out Condition a heat setting is set Outcome after the time has elapsed acoustic signal 00 flashes Cooking zone switches off acoustic signal 00 flashes Cooking zones not in use If just one countdown value is set you can change it only when the appliance is switched on. If a heat setting is set on this cooking zone in addition to a countdown timer, the cooking zone is switched off after the time set has elapsed. Control panel Touch Touch Touch Touch once once once once Display Pilot light of the first cooking zone flashes Pilot light of the second cooking zone flashes Pilot light of the third cooking zone flashes Pilot light of the fourth cooking zone flashes If other timer functions are set, after a few seconds the shortest remaining time of all the timer functions is displayed and the corresponding pilot light flashes. After a few seconds the pilot light flashes more slowly. Control panel Select a cooking zone Display Pilot light of cooking zone selected flashes faster Time remaining is displayed Control panel Select a cooking zone Display Pilot light of the selected cooking zone flashes more quickly Remaining time is displayed After a few seconds the pilot light flashes more slowly. Control panel field Select a cooking zone Display Pilot light of the cooking zone selected flashes faster The time remaining is displayed After a few seconds the pilot light flashes more slowly. If after switching on the cooking surface, a heat setting is not set for a cooking zone within approx. 10 seconds, the cooking surface automatically switches itself off. If one or more sensor fields are covered by objects (a pan, etc. 10 seconds, a signal sounds and the cooking surface switches off automatically. If all cooking zones are switched off, the cooking surface automatically switches itself off after approx. [. . . ] If the appliance has been operated incorrectly, the engineer's visit will be chargeable, even during the warranty period. The symbol on the product or on its packaging indicates that this product may not be treated as household waste. Instead it should be taken to the appropriate collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. [. . . ]