User manual AEG-ELECTROLUX A 75270-5 GA

[. . . ] Contents Thank you for choosing one of our high-quality products. To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. [. . . ] Once the required temperature has been set, after a short period (approx. ) the temperature indicator will show again the current ACTUAL temperature inside the corresponding compartment. the temperature indicator will change from flashing to continuous illumination. For a correct storage of the food the following temperature should be set: · -18 °C in the freezer. The following DESIRED temperature settings are possible: Operating mode "Freezing": from -15 °C up to -24 °C in 1 °C steps Operation mode "Cooling": from 0 °C up to 16 °C in 1 °C steps; When the setting is changed, the compressor does not start immediately if automatic defrosting is currently taking place. As the storage temperature within the appliance is reached quickly you can store food immediately after switching on. If necessary, switch over the appliance between the operating modes "Freezing" and "Cooling". When the setting is switched from "Freezing" to "Cooling" FC (Freezing - Cooling) appears in the temperature indicator, an acoustic signal confirms the change and the temperature indicator changes to flashing figures (DESIRED temperature cooling mode +5 °C). Using the temperature regulators, the required temperature for the cooling mode can now be entered. When the setting is switched from "Cooling" to "Freezing" CF (Cooling - Freezing) appears in the temperature indicator, an acoustic signal confirms the change and the temperature indicator changes to flashing figures (DESIRED temperature freezing mode -18 °C). Using the temperature regulators, the required temperature for the freezing mode can now be entered. The operation mode, in which your appliance is at the moment, is identifiable if the temperatures can be set above or below 0 °C. If you are using the appliance as a freezing unit, wait to add the food to be frozen, until the interior temperature has attained -18 °C. If you are using this appliance as a cooling unit, after it has been used as a freezing unit wait until the temperature has reached 0 °C before add the food to be cooled in the appliance. By selecting the DESIRED temperature in the range of +5 °C, this appliance can be used as a normal refrigerator. By selecting the DESIRED Temperature up to +16 °C, the appliance can perfectly be used as a cooling unit for drinks. The FROSTMATIC function accelerates the freezing of fresh food and, at the same time, protects foodstuffs already stored from undesirable warming. The FROSTMATIC function stops automatically after about 52 hours. An increase in the temperature in the freezer (for example due to an earlier power failure or door is open) is indicated by: · When normal conditions are restored: · Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brandnew product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. The freezer compartment is suitable for freezing fresh food and storing frozen and deepfrozen food for a long time. To freeze fresh food activate the FROSTMATIC function at least 24 hours before placing the food to be frozen in the freezer compartment. [. . . ] To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet. If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the shelves can be removed. [. . . ]