User manual AEG-ELECTROLUX A51100TSW0

[. . . ] FOR PERFECT RESULTS Thank you for choosing this AEG product. We have created it to give you impeccable performance for many years, with innovative technologies that help make life simpler ­ features you might not find on ordinary appliances. Please spend a few minutes reading to get the very best from it. ACCESSORIES AND CONSUMABLES In the AEG webshop, you'll find everything you need to keep all your AEG appliances looking spotless and working perfectly. [. . . ] Yellow Indicator Light lights in the switched-on state of the Freezer Switch. The Red Indicator Light will also illuminate until the correct temperature is reached. A few hours after starting up the Red Indicator Light will go out to show that the correct temperature has been reached for the setting chosen and will stay out to indicate that everything is in order. It will come on if the freezer temperature rises unduly for instance, after opening the freezer door or placing food inside the cabinet, but the light should go out again when the temperature returns to the correct storage level. When the appliance has reached the set temperature (the Red Indicator Light has gone out) press the Freezer Switch again to switch off the fast freeze function. To turn off the appliance, turn the Temperature Regulator to the "O" position. To disconnect the appliance from the power disconnect the mains plug from the wall socket. Turn the Temperature Regulator toward lower settings to obtain the minimum coldness. ⷠTurn the Temperature Regulator toward higher settings to obtain the maximum coldness. a medium setting is generally the most suitable. However, the exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: · room temperature · How often the door is opened · If more than 3-4 kg of food is to be frozen: 1. Press the Freezer Switch to activate the fast-freeze function 6-24 hours before placing the fresh food in the freezer, the Yellow Indicator Light will illuminate. The compressor will now run continuously, to ensure that the fresh food is frozen as quickly as possible. Place the food in the freezing (top) compartment and leave the Freezer Switch on for a further 24 hours. Then push the Freezer Switch again (the Yellow Indicator Light will go out and the switch turns to its original position). Move frozen food from the top (freezer) compartment into the other two compartments (storing compartments). for maximum freezing performance remove the top drawer (if the drawer is foreseen) and then place the foods to be frozen directly on the evaporator. In case of freezing smaller food volumes you do not need to remove the drawer. If the Freezer Switch is accidentally left on, the freezer will not be damaged, but energy will be wasted. Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. The freezer (top) compartment is suitable for freezing fresh food and storing frozen and deep-frozen food for a long time. [. . . ] To ensure best performance, if the appliance is positioned below an overhanging wall unit, the minimum distance between the top of the cabinet and the wall unit must be at least 100 mm . Ideally, however, the appliance should not be positioned below overhanging wall units. Accurate levelling is ensured by one or more adjustable feet at the base of the cabinet. If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the shelves can be removed. [. . . ]