User manual AEG-ELECTROLUX A60190GS5

[. . . ] Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Cover the holes left open with the plugs contained in the documentation pack. Attention: After having reversed the opening direction of the doors check that all the screws are properly tightened and that the magnetic seal adheres to the cabinet. In Winter), the gasket may not fit perfectly to the cabinet. In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. Alarm light (red) Fast feezing light (yellow) Fast feezing switch and reset sound signal alarm Operating light (green) Temperature regulator - ON/OFF knob The green pilot lamp (D), which comes on when the mains voltage is available and the ON/OFF knob is pushed. Switch the temperature regulatore to a number position, the refrigerating unit automatically operates by system control. The temperature regulator (E), which can be used for continuously variable setting of the most energy saving storage temperature for your frozen food. the optimum storage conditons occur at -18°C. The yellow pilot light (B) comes on when the switch (C) has been pushed. The red temperature pilot-lamp (A) blinks when: ­ the appliance has been started up but the storage temperature has not yet been attained; ­ the minimum storage temperature is no longer being maintained (fault); ­ excessive amounts of fresh food are placed inside; or Important note: if you operate the fast-freeze switch or adjust the temperature regulator, it may happen that your appliance's refrigeration motor does not start immediately but only after some time. This does not mean that your appliance has a fault. Please clean the appliance interior and all accessories prior to starting the appliance. To reset the sound alarm push the botton (C) and the alarm light (A) blinks until the reaching of the storage temperature . The yellow pilot lamp (B) comes on by pressing the switch (C) again . ⷠOnly when the red lamp (A) has gone out should you reset the fast-freeze switch (C) the yellow light (B) goes out by pressing the switch (C) again. The exact setting should be chosen keeping in mind that the temperature inside the appliance depends on: - the quantity of food stored - how often the door is opened - ambient temperature Important: Regularly check on the red temperature pilot lamp (A) that the required storage temperature is being maintained. [. . . ] ⷠPut frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge. ⷠKeep the heat emitting condenser, the metall grille on the rear wall of your appliance, always clean. A malfunction may be caused by only a minor fault that you can rectify yourself using the following instructions. [. . . ]