User manual AEG-ELECTROLUX A60300GS2

[. . . ] Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] In that case, wait for the natural fitting of the gasket or accelerate this process by heating up the part involved with a normal hairdrier. Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. Alarm light (red) Fast feezing light (yellow) Fast feezing (FROSTMATIC) switch/reset sound alarm signal Operating light (green) Temperature regulator knob The green pilot lamp (D), which comes on switching the temperature regula-tore to a number position, the refrigerating unit automatically operates. The fast-freeze button (C) with its yellow pilot light (B). The yellow pilot light comes on when the switch has been operated. the refrigerating unit then operates continuously. The red temperature warning light (A) blinks on when: ­ the appliance has been started up but the storage temperature has not yet been reached; ­ the minimum storage temperature is no longer being maintained (fault); ­ excessive amounts of fresh food are placed inside; or ­ if the appliance door is open for too long. The temperature regulator can be used for the variable setting of the storage temperature for your frozen food. The following effects are of significance in respect of the interior temperature: ­ Ambient temperature; ­ Quantity and temperature of the food stored; ­ Frequency with which the door is opened and how long it is left open. The following temperature settings can therefore only be considered as recommendations that may well need to be adapted to suit your particular situation. Turn the temperature regulator (E) in the direction of , , O"; The compressor starts and then runs automatically. If the quick-freezing function is not ended manually, the appliance switch off the quick-freezing function after 52 hours. The temperature regulator (E) can be used to set the required storage temperature, -18°C or colder. Wait until the freezer compartment has reached a temperature of ­18°C, or the red warning light has gone out, before storing frozen food. Important: Regularly check on the red temperature pilot light (A) that the required storage temperature is being maintained. You can use your freezer for freezing fresh food yourself. The temperature in the freezer compartment must be ­18 °C or colder before freezing food. [. . . ] ⷠPut frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge. ⷠKeep the heat emitting condenser, the metall grille on the rear wall of your appliance, always clean. A malfunction may be caused by only a minor fault that you can rectify yourself using the following instructions. [. . . ]