User manual AEG-ELECTROLUX A70128GS

[. . . ] ARCTIS 70128 GS Freezer Operating Instructions Dear customer, Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Press either the , , +" (WARMER) or , , -" (COLDER) button. The temperature display switches over and the DESIRED temperature currently set flashes on the temperature display. Set the required temperature by pressing the , , +" (WARMER) or , , -" (COLDER) buttons (see section "Temperature setting buttons"). The temperature display will immediately show the changed setting. With 14 each further press of one of the two buttons, the DESIRED temperature is adjusted by one display field. From a food safety point of view -18°C should be considered sufficiently cold for storing food in the freezer. Once the required temperature has been set, after a short period (approx. 5 sec. ) the temperature display will change and again indicate the current ACTUAL temperature inside the fridge. The display will change from flashing to continuous illumination. The compressor will start and then run automatically. When the setting is changed, the compressor does not start immediately if automatic defrosting is currently taking place. Wait until the freezer compartment has reached a temperature of -18°C before storing frozen food. FROSTMATIC FROSTMATIC button The FROSTMATIC function accelerates the freezing of fresh food and, at the same time, protects foodstuffs already stored from undesirable warming. The FROSTMATIC function is switched on by pressing the FROSTMATIC button. If the FROSTMATIC function is not ended manually, the appliance electronics switch off the FROSTMATIC function after 48 hours. The FROSTMATIC function can be ended manually at any time by pressing the FROSTMATIC button again. The yellow light goes out. 15 Switching off the appliance To switch off, press the ON/OFF button until the mains power light extinguishes. If the appliance is not going to be used for an extended period: 1. Remove all deep-frozen packages as well as ice-trays. Switch off the appliance by pressing the ON/OFF button until the mains power light extinguishes. Remove the mains plug or switch off or disconnect the electricity supply. Defrost freezer and clean thoroughly (see section: "Defrosting and Cleaning"). Leave the door open to avoid the build up of odours. Freezing and storing frozen food You can use your freezer for freezing fresh food yourself. [. . . ] Move the appliance slightly. Heavy build up of frost, possibly also on the door seal. Door seal is not air tight (possibly after reversing the door). Appliance is not level. The appliance is touching the wall or other objects. The compressor does not start immediately after changing the temperature setting. This is normal, no error has The compressor starts after occurred. a period of time. Important: regularly check on the red temperature pilot light and temperature display to establish that the storage temperature is being maintained. Noises during Operation The following noises are characteristic of refrigeration appliances: · Clicks Whenever the compressor switches on or off, a click can be heard. · Humming As soon as the compressor is in operation, you can hear it humming. [. . . ]