User manual AEG-ELECTROLUX A70220GS

[. . . ] Taste Alarm off Before placing your new refrigerator/freezer into operation please read these operating instructions carefully. They contain important information for safe use, for installation and for care of the appliance. Please keep these operating instructions for future reference. Pass them on to possible new owners of the appliance. [. . . ] Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. These buttons are connected to the temperature display. The temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, , , B" or , , D". Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. The DESIRED temperature must be reached within 24 hours. If neither button is pressed, the temperature display automatically switches back after a short period (approx. The temperature display can indicate several pieces of information. During normal operation, the temperature currently present in the freezer (ACTUAL temperature) is displayed. When the temperature is being adjusted a flashing display indicates the freezer temperature currently set (DESIRED temperature). Press the "I" button to stop the buzzer, the light still flashes since the temperatur is reached. The temperature display will immediately show the changed setting. From a food safety point of view -18 °C should be considered sufficiently cold for storing food in the freezer. The FROSTMATIC function accelerates the freezing of fresh food and, at the same time, protects foodstuffs already stored from undesirable warming. If the FROSTMATIC function is not ended manually, the appliance electronics switch off the FROSTMATIC function after 52 hours. The FROSTMATIC function can be ended manually at any time by pressing the FROSTMATIC button again. Power cut) warning light (G) will start to flash and a buzzer will sound. After the temperature has returned to normal, the warning light (G) will continue to flash, although the buzzer has stopped. [. . . ] ⷠPut frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge. ⷠKeep the heat emitting condenser, the metall grille on the rear wall of your appliance, always clean. A malfunction may be caused by only a minor fault that you can rectify yourself using the following instructions. [. . . ]