User manual AEG-ELECTROLUX A75270GA1

[. . . ] Taste Alarm off Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] The supply must have a fuse rating of at least 10 Amps. If the socket is not accessible once the appliance is built in, the electrical installation must include suitable means of isolating the appliance from the mains (e. Fuse, cut-out, current trip or similar with a minimum contact separation of 3 mm). attention: The mains connection cable may only be replaced by a skilled electrician. Please contact your dealer or our customer service department for repairs. These buttons are connected to the temperature display. ⷠThe temperature display is switched over from the display of the ACTUAL temperature (Temperature display is illuminated) to the display of the DESIRED temperature (Temperature display flashes) by pressing one of the two buttons, , , B" or , , D". ⷠEach time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. The DESIRED temperature must be reached within 24 hours. If neither button is pressed, the temperature display automatically switches back after a short period (approx. If necessary, switch over the appliance with the following steps between the operating modes "Freezing" and "Cooling": Hold down the SUPER button and the , , +" (WARMER) button simultaneously for 5 seconds. ⷠWhen the setting is switched from "Freezing" to "Cooling" "FC" (Freezing Cooling) appears in the temperature display, an acoustic signal confirms the change and the temperature display changes to flashing figures (DESIRED temperature cooling mode +5 °C). Using the temperature setting buttons, the required temperature for the cooling mode can now be entered. ⷠWhen the setting is switched from "Cooling" to "Freezing" "CF" (Cooling - Freezing) appears in the temperature display, an acoustic signal confirms the change and the temperature display changes to flashing figures (DESIRED temperature freezing mode -18 °C). Using the temperature setting buttons, the required temperature for the freezing mode can now be entered. The operation mode, in which your appliance is at the moment, is identifiable if the temperatures can be set above or below 0 °C. If you are using the appliance as a freezing unit: Please wait prior to putting the foodstuff to be frozen, until the freezer interior temperature has attained -18 °C. If you are using this appliance as a cooling unit, after it has been used as a freezing unit: Please wait until the temperature has reached 0 °C before putting the foodstuff to be cooled in the appliance. The changed setting is immediately displayed on the temperature display. Each time one of the two buttons is pressed again the DESIRED temperature is adjusted by 1 °C. The following DESIRED temperature settings are possible: · operating mode "Freezing": from -15 °C up to -24 °C in 1 °C steps; · Operation mode "Cooling": from 0 °C up to 16 °C in 1 °C steps; If the buttons are not pressed again the temperature display will change after approx. By selecting the DESIRED temperature in the range of +5 °C, this appliance can be used as a normal refrigerator. [. . . ] ⷠPut frozen food in the fridge to defrost. The cold in the frozen food will then be used to cool the fridge. ⷠKeep the heat emitting condenser, the metall grille on the rear wall of your appliance, always clean. A malfunction may be caused by only a minor fault that you can rectify yourself using the following instructions. [. . . ]