User manual AEG-ELECTROLUX A803KF

[. . . ] Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss (refer to relevant instructions for unit installation under point 4. ). Before defrosting, cleaning or maintenance work is carried out, be sure to switch off the appliance and unplug it. Manufacturers' food storage recommendations should be strictly adhered to. Refer to relevant instructions for food and drink storage under point 13. [. . . ] Recommendation: before journey, pre-cool the unit using A/C operation. To turn on Plug the car plug must be mounted according to your car on the connecting cable into the plug connector/cigarette lighter. When using battery operation, the cooling performance is not thermostatically regulated, i. e. When knob (A) is ineffective or if the temperature is unnecessarily too low: Turn off unit Pull out plug from socket. 5 8. Liquid gas operation Do not use any additional form of energy (mains/battery). The unit must not be connected to town or natural gas pipelines. It is only suitable for use with propane/butane gas (e. g. Calor Gas, Camping Gaz, Caravangas, etc). The refrigerator is equipped for a specific gas-pressure, corresponding to the standard pressure of the country in which it is sold. The rating-plate states the pressure which is correct. It is important that a non adjustable pressureregulator is used to reduce the pressure in the gas cylinder to the operating pressure specified on the rating-plate, no other pressure may be used. Needle valve operated gas control taps are NOT suitable for use with this appliance and must not be used as a substitute for a pressure regulator. Always connect in the following sequence: GAS BOTTLE PRESSURE-REGULATOR APPLIANCE. The gas bottle must only be used in an upright position and particular care must be taken every time the appliance is connected to the gas bottle to ensure that there are no leaks, that the gas pipe (rubber hose) is not under tension or kinked, and that it is not in contact with hot surfaces. The connection pipe and gas bottle should always be located in positions where they will not be tripped over or otherwise inadvertently disturbed. Before attempting to light the burner, every time after connection, turn on the gas at the bottle and check the gas connections for leaks by applying a soap and water solution over them and watching for bubbles, which would indicate a leak. For your safety Do not check for leaks with a naked flame!Do not smoke while checking for leaks! 9. 1) The gas equipment consists of a multiple value (B) [value with built-in thermoelectric ignition control], the piezo-gas lighter (E), a burner with sparking plug and the gasthermostat. Knob (B) can be turned to 2 function positions: : large flame = gas-flow open; : out position = gas supply to burner is closed. If, for any reason the gas flame extinguishes, the ignition control is working automatically and shuts off gas supply. 6 (Fig. 1/2) 3-way-switch (D) should be in position "0" Open gas cylinder or pressure regulating valve. [. . . ] - does the liquid gas cylinder still contain gas?If no liquid movement is evident on shaking the cylinder, then the gas cylinder is empty. - are several operating methods being used simultaneously?- have warm foodstuffs been stored in the cooler? 8 - was a too large a quantity of food or drink stored at any one time? [. . . ]