User manual AEG-ELECTROLUX AE7345

[. . . ] To ensure optimal and regular performance of your appliance please read this instruction manual carefully. It will enable you to navigate all processes perfectly and most efficiently. To refer to this manual any time you need to, we recommend you to keep it in a safe place. and please pass it to any future owner of the appliance. [. . . ] If these clearances cannot be maintained a heat insulating pad is required between the cooker and the refrigeration appliance. If the refrigeration appliance is installed next to another refrigerator or freezer a clearance of 5 cm at the sides is required, in order to prevent the formation of condensation on the outside of the appliance. "Installation directly under a hob is not allowed. The temperatures of the hob, which in part are quite high, may damage the appliance. If a hob is installed near the appliance, the corresponding installation and safety instructions must be adhered to. Considering the numerous installation conditions which are possible, there is no way of providing detailed information here. It is necessary to avoid overheating of the refrigerator by maintaining adequate distances from heat sources and by the use of a suitable thermal insulation plate. Proper ventilation of the appliance must also be ensured. Your appliance needs air for safety reasons , minimum ventilationmust be as shown Fig. Attention: keep ventilation openings clear of obstruction; Before initial start-up, refer to the appliance rating plate to ascertain if supply voltage and current values correspond with those of the mains at the installation location. The supply must have a fuse rating of at least 10 Amps. The FROSTMATIC function accelerates the freezing of fresh food and, at the same time, protects foodstuffs already stored from undesirable warming. Nics switch off the FROSTMATIC function after 52 hours. The FROSTMATIC function can be ended manually at any time by pressing the FROSTMATIC button again. Power cut) warning light (H) will start to flash and a buzzer will sound. After the temperature has returned to normal, the warning light (H) will continue to flash, although the buzzer has stopped. To switch off, hold down the ON/OFF button for approx. This will result in a countdown from "3" to "1" taking place in the temperature display. Note: The appliance cannot be switched on or off if unplugged, or if there is no power being supplied to it. Following connection to the mains power supply, the appliance returns to the same operating state as before the interruption of main power. If the appliance is not going to be used for an extended period: Switch off the appliance, holding down the ON/OFF button until the display goes off (see above). Remove the mains plug or switch off or turn out the circuit breaker or fuse. [. . . ] Switch off the appliance and pull out the plug, or remove or unscrew the safety fuses. Do not install the appliance near cookers, radiators or other sources of warmth. High ambient temperatures cause longer, more frequent operation of the compressor. Do not place warm foods into the appliance. [. . . ]