User manual AEG-ELECTROLUX AEG A3506

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets... DON'T FORGET : ALWAYS READ THE USER GUIDE BEFORE BUYING !!!

If this document matches the user guide, instructions manual or user manual, feature sets, schematics you are looking for, download it now. Lastmanuals provides you a fast and easy access to the user manual AEG-ELECTROLUX AEG A3506. We hope that this AEG-ELECTROLUX AEG A3506 user guide will be useful to you.

Lastmanuals help download the user guide AEG-ELECTROLUX AEG A3506.


Mode d'emploi AEG-ELECTROLUX AEG A3506
Download
Manual abstract: user guide AEG-ELECTROLUX AEG A3506

Detailed instructions for use are in the User's Guide.

[. . . ] INSTALLATION The accessories necessary for the installation of the hood can be found inside it. The hood is convertible and it can, therefore, be installed in either the SUCTION or DEPURATION versions. In the event that the hood is used in its SUCTION version, connect the opening (125 mm diameter) (Fig. 2) to an evacuation duct directly connected to the exterior and which has a minimum section of 150cm2. [. . . ] 3. 1), thereafter affix the other 2 supporting angles E to the rear part of the motor housing but this time the folds E2 must be facing outwards (Fig. During this phase, it is possible to regulate the predetermined height of the hood by fixing the 4 supporting angles E in the dedicated adjustment holes on the hood. Install the motor frame joining the 4 supporting angles by means of the stiffener F (positioned as per fig. Insert the casing H on the motor frame keeping the vents for filtering operation towards the top and laterally; thereafter, insert casing I over casing H (fig. Lift the entire unit, keeping it slightly back from plate A attached to the ceiling (Fig. Thereafter push it forward supporting it towards the ceiling in a way that the vents E1 and E2 of the 4 supporting angles E will insert themselves into the front and lateral dowels of plate A provided with a backstop (fig. Proceed then to attach the motor frame using 8 screws (Fig. Carry out the electrical and air discharge tube connection. 7. 1) (left and right respectively) and remove the fixing angle identified with letter "Z" (Fig. Position glass "Q" on the upper side of the hood. Slide from above, through the horizontal slit corresponding to fixing angle "Z", previously removed, until the short side of the fixing angle is placed horizontally on the glass. Pay careful attention that the hot-plates are always covered in a manner which does not cause the filter to overheat and to catch fire. Never fry leaving the pot unsupervised: the oil contained in the pot could overheat and catch fire. In the case of used oil, the risk of spontaneous combustion is greater. It is absolutely forbidden to carry out open-fire cooking (eg. The collected air must not be conveyed in a duct used for the discharge of smoke from appliances fed by energy sources other than electricity, furthermore, adequate aeration must be provided in the room when the hood and appliances fed by energy sources other than electricity are used at the same time. If the hood is used in suction mode, make sure that the discharge vent is in a good condition if it has not been used for a long period of time. Remember to comply with existing local regulations and with the regulations of the competent authorities with regards to the discharge of air to be evacuated when the hood is operating in suction mode. All the recommendations herein provided must be scrupulously adhered to in order to avoid possible fires. THE MANUFACTURER DECLINES ALL RESPONSIBILITY IN THE EVENT OF FAILURE TO OBSERVE THE INSTRUCTIONS GIVEN HERE FOR INSTALLATION, MAINTENANCE AND SUITABLE USE OF THE HOOD. K717380002. doc COMANDI ELETTRONICI CARATTERISTICHE: TOUCH CONTROL ELECTRONIC CONTROLS SPECIFICATIONS: TOUCH CONTROL ELEKTRONISCHE STEUERUNGEN EIGENSCHAFTEN TOUCH CONTROL T asto: 1 2 3 4 5 Key: 1 2 3 4 5 T aste: 1 2 3 4 5 I COMANDI ELETTRONICI INSTALLATI SULLA VOSTRA CAPPA ASPIRANTE SONO DOTATI DI MOLTEPLICI FUNZIONI-CARATTERISTICHE: -FUNZIONE ON-OFF MOTORE. PREMENDO IL TASTO NR. 1 SI ACCENDE O SI SPEGNE IL MOTORE. ALL'ACCENSIONE LA CAPPA PARTE AUTOMATICAMENTE IN TERZA VELOCITA'. [. . . ] QUANDO SI PREME IL TASTO SUL DISPLAY APPARE UN "-" (INDICA CHE LA CAPPA NON UTILIZZA IL FILTRO CARBONE) CHE DOPO 5 SECONDI DIVENTA UN "C" (INDICA CHE LA CAPPA UTILIZZA IL FILTRO CARBONE). DA QUESTO MOMENTO IL MICROPROCESSORE OGNI 120 ORE D'UTILIZZO SEGNALERA' DI SOSTITUIRE IL FILTRO CARBONE USATO FACENDO LAMPEGGIARE SUL DISPLAY UNA "C". QUESTO PER GARANTIRE LA MIGLIORE ASPIRAZIONE E LA MIGLIORE IGIENE AMBIENTALE. PER CANCELLARE IL MESSAGGIO D'AVVERTIMENTO UNA VOLTA SOSTITUITI I FILTRI CARBONE SI DEVE, A CAPPA COMPLETAMENTE SPENTA, TENERE PREMUTO IL TASTO NR. [. . . ]

DISCLAIMER TO DOWNLOAD THE USER GUIDE AEG-ELECTROLUX AEG A3506

Lastmanuals offers a socially driven service of sharing, storing and searching manuals related to use of hardware and software : user guide, owner's manual, quick start guide, technical datasheets...
In any way can't Lastmanuals be held responsible if the document you are looking for is not available, incomplete, in a different language than yours, or if the model or language do not match the description. Lastmanuals, for instance, does not offer a translation service.

Click on "Download the user manual" at the end of this Contract if you accept its terms, the downloading of the manual AEG-ELECTROLUX AEG A3506 will begin.

Search for a user manual

 

Copyright © 2015 - LastManuals - All Rights Reserved.
Designated trademarks and brands are the property of their respective owners.

flag